Dremel MultiPro 395 Carbon Brushes Replacement - The-Eye.eu!
Dremel MultiPro 395 Carbon Brushes Replacement
Dremel MultiPro 395 Carbon Brushes Replacement Often the carbon brushes on the MultiPro will wear down and need replacing.
Written By: Matthew Satton
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
Dremel MultiPro 395 Carbon Brushes Replacement
INTRODUCTION This guide will show how to replace damaged or dirty carbon brushes in the Dremel MultiPro 395.
TOOLS: 3mm Flathead Screwdriver (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
Dremel MultiPro 395 Carbon Brushes Replacement
Step 1 — Remove the Blue Caps
Remove the blue caps located on either side of the MultiPro using a 3 mm flathead screwdriver.
Step 2 — Remove the Carbon Brushes
Carefully remove the carbon brushes attached at the end of the springs by gently pulling on the springs using your hands.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 4
Dremel MultiPro 395 Carbon Brushes Replacement
Step 3 — Insert New Carbon Brushes
Carefully insert the new carbon brushes into the location of the old carbon brushes using your hands.
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-23 08:51:31 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
Dremel MultiPro 395 Carbon Brushes Replacement Often the carbon brushes on the MultiPro will wear down and need replacing.
Written By: Matthew Satton
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
Dremel MultiPro 395 Carbon Brushes Replacement
INTRODUCTION This guide will show how to replace damaged or dirty carbon brushes in the Dremel MultiPro 395.
TOOLS: 3mm Flathead Screwdriver (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
Dremel MultiPro 395 Carbon Brushes Replacement
Step 1 — Remove the Blue Caps
Remove the blue caps located on either side of the MultiPro using a 3 mm flathead screwdriver.
Step 2 — Remove the Carbon Brushes
Carefully remove the carbon brushes attached at the end of the springs by gently pulling on the springs using your hands.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 4
Dremel MultiPro 395 Carbon Brushes Replacement
Step 3 — Insert New Carbon Brushes
Carefully insert the new carbon brushes into the location of the old carbon brushes using your hands.
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-23 08:51:31 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
