MAX POWER ORGANICS ™ INVADER ™ NON-IONIC SURFACTANT ACTIVE INGREDIENT: Garlic Extracts ……………………………………………………………………… 15.0% Components ineffective as a spray adjuvant *………………………………….….… 85.0% Total …..… 100% *Formulated with Citric Acid, Acetic Acid, Mineral oil, Sodium Lauryl Sulfate, and Water All ingredients are exempt from tolerance requirements under 40 CFR, 180.1001 and 180.1164
Keep Out of Reach of Children
CAUTION
Liquid causes eye injury. Avoid contact with skin, eyes or clothing (wear long sleeved shirt, long pants, shoes plus socks). Harmful if swallowed or absorbed through skin. Wash thoroughly with soap and water after handling. Si usted no lee entiende la etizueta, busque a alguien para que se la explique a usted en detalle. (If you do not understand this label, find someone to explain i t to you in detail.) Statement of Practical Treatment If Swallowed: Call a physician or Poison Control Center immediately. Induce vomiting promptly If on Skin: Remove contaminated clothing and wash with soap and water. Get medical attention if irritat ion persists. If in Eyes: Flush with water for at least 15 minutes, then get medical attention. If Inhaled: Remove victim to fresh air; apply artificial respiration if necessary.
Net Contents: 2.5 Gallons *Shake container well before using* Made in the USA
This product is protected under U.S. Patent #6,511,674
GENERAL INFORMATION INVADER is a low foaming, non-ionic type spreader adjuvant. INVADER provides quick wetting, more uniform distribution, and increases retention of spray by reducing surface t ension of the spray droplets. INVADER is a water soluble adjuvant that may also be used as an interfacing agent for wett able powders. Variations in conditions of use can cause some variation in the amount of INVADER required.. The minimum required to giv e a smooth, uniform coverage usually gives the most effective results. DIRECTIONS FOR USE Some pesticides have stated adjuvant use rates. In all cases, the pesticide manufacturer’s label should be consulted regardi ng specific adjuvant use recommendations and that rate followed. Do not add adjuvant at a level that would exceed 5% of the finished spray volume. Herbicides, Defoliants, Desiccants : 2 quarts/100 gallons of spray mixture Insecticides, Fungicides, Acaracides, Plant Growth Regulators, Foliar Nutrients: 2 quarts/100 gallons of spray mixture Turf, Ornamental and Industrial Spraying: 3.2 ounces per 5 gallons of spray mixture. Note: This product has demonstrated excellent plant safety; however, not all species and varieties have been tested . Before treating a large area, treat a small area and observe prior to full -scale application. Do not use on roses. Do not use this product with Copper or Tin based fungicides or proprionic acid. MIXING INSTRUCTIONS Prior to pesticide application, c lean mixing and application equipment according to pesticide label directions Adjust spray tank pH to a maximum of 6.0 before adding INVADER to the tank. For wettable powders and water soluble materials, add INVADER in water before adding pesticide to spray tank. For emulsifiable products, add INVADER after a good emulsion is formed. Note: For optimum results, spray mixes containing INVADER should be applied within 36 hours. STORAGE AND DISPOSAL Do not contaminate water, food or feed by storage or dis posal. Do not store near heat or open flame. Store container in a cool dry place. Pesticide: Wastes resulting from the use of this product may be disposed of on site or at an approved waste disposal facility. Container Disposal: Triple rinse (or equivalent). The offer for recycling or reconditioning, or puncture and dispose of in a sanitary landfill, or incineration, or, if allowed by state and local authorities, by burning. If burned, stay out of smoke. In the event of a major spill, fire or othe r emergency, call (760)-994-7922 day or night. CONDITIONS OF SALE AND WARRANTY
IMPORTANT: Read the entire Directions for Use and the Conditions of Sale and Warranty before using this product. If the terms are not acceptable, return the unopened product container at once. The Directions for Use are believed to be reliable and should be followed carefully. However, it is impossible to eliminate all risks inherently associated with the use of this product. Crop injury, ineffectiveness or other unintended con sequences may result because of such factors as weather conditions, presence of other materials or the manner of use or application, all of which are beyond the control of Cal Crop USA II, LLC or the Seller. All such risks shall be assumed by the Buyer. Cal Crop USA II, LLC warrants that this product conforms to the chemical description on the label and is reasonably fit for the purpose referred t o in the Directions for Use subject to the inherent risks referred to above. Cal Crop USA II, LLC makes no other express or implied warranty of Fitness or Merchantability or any other express or implied warranty. In no case shall Cal Crop USA II, LLC or the Seller be liable for consequential, special or indirect damages resulting from the use or handling of this product. Cal Crop USA II, LLC and the Seller offer this product, and the Buyer and User accept it, subject to the foregoing Conditions of Sale and Warranty , which may be varied only by agreement in writing and signed by a duly authorized representative of Cal Crop USA II, LLC
Manufactured by: Cal Crop USA II, L.L.C P.O. Box 698 Bonsall, CA 92003 Invader and Max Power Organics are Trademarks of the Cal Crop USA II, L.L.C.