Mount Guide


Linear Servo. Shifter. Assembly/Mount ... Gear onto the Servo. Linear Servo Assembly/Mount ... to the Motor Plate and attach using two. 10-32 Phillips Head ...

Linear Servo Shifter Assembly/Mount Guide

for

1 www.andymark.com

Linear Servo Assembly/Mount Step 1: Attach the Slide Block to the Servo Bracket using two 10-32 Phillips Head Screws.

Step 4: Attach and tighten four sets of 8-32 Screws with their respective Nylon Nuts to set the Servo in place.

Step 2: Screw the Encoder into place. Step 5: Attach and screw on the 12 Tooth Servo Gear onto the Servo.

Step 3: Slide the Servo through the servo slot on the Bracket.

2 www.andymark.com

Step 6: Rotate the servo counterclockwise until it reaches the end of its path. Step 8: Place the washer on Shoulder Screw and screw into Slide Block through the Slide Rack.

Step 7: Slide and push the Slide Rack onto the Slide Block, rotating the gear while pushing into position.

Step 9: Slide the ¼”-28 Screw through the Slide Rack and place the Rubber ORing on the other side.

3 www.andymark.com

Step 10: Line the Servo Shifter holes up to the Motor Plate and attach using two 10-32 Phillips Head Screws.

Step 11: Screw the ¼”-28 Screw with the Rubber O-Ring into the Shifter block.

4 www.andymark.com

Recommend Documents
Aug 28, 2015 - For brick & mortar, concrete, and glass applications, please view our application note for installation on our website, www.iportproducts.com.

RED MOTION MOUNT Ti PL. 29. RED MOTION MOUNT Ti Canon. 29. Neutral Density and Shutter Angles. 30. Maximum Frame Rates. 31. Appendix B: MOTION ...

b) Polarity reversal input from FACP signaling circuit. Visual Indicators: • Individual Output Status LEDs located on the front panel. Battery Backup: • Built-in charger for sealed lead acid or gel type batteries. (A separate enclosure is require

Removing the Hard Drive . ... Placing Hard Drive Directly into Posiflex Screen . ... Place your Posiflex touch screen on a flat clean surface. Disconnect hard drive ...

installation, contact Customer Service or call a qualified contractor. Rocketfish is .... The center of your TV will match the center of the wall plate (A). Before you ...

This Class B digital apparatus complies with Canadian ICES-003. Le présent appareil est conforme aux CNR d'Industrie Canada ap- plicables aux appareils ...

en boisNota: localice primero las vigas de madera. Need help deciding how high to mount your TV? Scan this QR code. Besoin d'aide pour déterminer la hauteur de montage du téléviseur? Numériser ce code QR. ¿Necesita ayuda para determinar la altur

This Class B digital apparatus complies with Canadian ICES-003. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils ...

See instructions on back. Lag pull-out (withdrawal) capacities (lbs) .... top tile flashing installation (steps 7-8 on page 2). ... downloads.html. For more information ...