Nostalgia Electrics PCM805 Extractor Head Replacement

Nostalgia Electrics PCM805 Extractor Head Replacement

Nostalgia Electrics PCM805 Extractor Head Replacement This guide shows removing the extractor head.

Written By: Carlton

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 4

Nostalgia Electrics PCM805 Extractor Head Replacement

INTRODUCTION Use this guide to replace your extractor head if it is damaged.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 4

Nostalgia Electrics PCM805 Extractor Head Replacement

Step 1 — Bowl

 Make sure that the device is unplugged and has not been used recently because the extractor head and bowl can be very hot. 

Place the device on a steady table.



Lift and remove the rim.

Step 2



Twist the bowl clockwise until it is free of the groove and lift to remove.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 4

Nostalgia Electrics PCM805 Extractor Head Replacement

Step 3 — Extractor Head



Firmly grip the extractor head and slowly lift vertically to remove from the device.

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-07-05 08:28:45 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 4