Rally Ripster™ Rally Ripster - FCC ID

Report 1 Downloads 13 Views
BX1235-Inst

Press

F OrFi e s ! UTOa t t e c a r,

A ves b

) te iva utton t c b a e e r l (to h litt pu s

®

1

sa

Rally Ripster



1 To 4 years

Designed for little hands and big laughs Easy to turn when it hits a wall or a brother Powerful radio signal works across rooms Shuts itself off when little kids forget 1 to jump-start just push the little button 2 then push the one-button remote again, and...”wheeeeeeeee”! Try it in the dark! Colors light up your room like a toddler disco!

JOB NO: 2013-6-32 BX1235-Inst

Pms 4695 U

2

h one button you t i d - t. W c l o r n o t i rol the w t least one very imp of a t r r ortant tle pa o lit

JOB NAME: BX1235-Rally-Ripster-Wheeee-Mote-IS.ai

DATE: 2013-6-27

BX1235-Inst BX1235

9V

9V

Open

®

Lock

Rally Ripster

Open



Lock

1 To 4 years

• Please replace the pre-installed AA batteries at home (those were only for demo of lights + sounds). • Do not mix old and new batteries. • Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries. • Dead batteries? Check out earth911.com to quickly find the recycling center nearest you.

JOB NO: 2013-6-32 BX1235-Inst

Get the whole story at justb-byou.com. If you have questions or comments, race to the phone and call us (toll free).

I-866-665-5524

© 2013 Maison Joseph Battat Ltd. B. and Rally Ripster and Just B. Just You. B. You are trademarks of Maison Joseph Battat Ltd. Manufactured for Maison Joseph Battat Ltd. 8440 Darnley Road, Montreal, P.Q. H4T 1M4 Designed by Maison Joseph Battat Ltd. Consumer Information Line: 1-866-665-5524

JOB NAME: BX1235-Rally-Ripster-Wheeee-Mote-IS.ai

DATE: 2013-6-27

Pms 4695 U

Cruise over to B.

4 AA (1.5V) batteries included for car 9V battery not included for remote

100% RECYCLED WOOD-FREE PAPER PRINTED WITH SOY-BASED INKS

REPLACING BATTERIES

• Print in PMS440 U (SOY-BASED INKS) • Print on 128 g 100% Recycled Woodfree Paper • Don’t print dieline

curious

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Caution: changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help.

Congratulations! You read through all of that tiny text? Your eyes are very good, and your patience is admirable.