2TouchPOS Wall Mount User's Guide

Report 4 Downloads 90 Views
2TouchPOS Wall Mount User’s Guide

2013 Xenios LLC 82 Saint Paul Street Rochester, NY 14604 Phone 585.325.5242 • Fax 585.325.6989

Contents About this Document ...................................................................................................................... 3 Removing the Hard Drive ........................................................................................................... 4 Placing Hard Drive Directly into Posiflex Screen ...................................................................... 8 Attaching Posiflex Touch Screen to Wall Mount ..................................................................... 12

Xenios LLC @2013

Page 2

About this Document This document was written for 2TouchPOS version 3.03.4900.

Xenios LLC @2013

Page 3

Removing the Hard Drive 1. First, you will turn off the power to your Posiflex terminal. Tilted the Posiflex terminal back and unplug power cable.

Xenios LLC @2013

Page 4

2. In the front part of your Posiflex terminal, there is a plastic plate; you will remove plastic plate to expose the hard drive. Press down on the clip release and remove plastic plate.

3. Using a Phillips head screwdriver, unscrew the single screw.

Xenios LLC @2013

Page 5

4. Pull down on the metal bar and slide hard drive tray out.

Xenios LLC @2013

Page 6

5. Unscrew all four screws and remove hard drive.

Xenios LLC @2013

Page 7

Placing Hard Drive Directly into Posiflex Screen 1. Remove Base Terminal stand by pressing plastic clip, located on the backside of your terminal. Hold the clip, place other hand on the terminals front side of your Posiflex touch screen and lift screen up.

Xenios LLC @2013

Page 8

2. Place your Posiflex touch screen on a flat clean surface. Disconnect hard drive power and sata cables.

3. Top right hand corner of the terminal, there are two screws you will remove, then take plastic plate off. The hard drive will be placed into here.

Xenios LLC @2013

Page 9

4. Once plastic plate is removed, you will see two cables, hard drive power and sata cable.

Xenios LLC @2013

Page 10

5. Connect hard drive with hard drive power and sata cables.

6. Once cables are attached, slide hard into drop down area. Reattached plastic plate with the two screws.

Xenios LLC @2013

Page 11

Attaching Posiflex Touch Screen to Wall Mount 1. In the Wall Mount hardware package, there are wall mounting instructions and measurements that will help you mount your Posiflex screen onto the wall. 2. The diagram instruction sheet is used to drill holes into the wall matching bracket screw holes. 3. Take the wall mounting diagram sheet and place it against the wall. Take a pair of scissors and cut wholes in diagram sheet, then mark wall with a pencil, where you will drill holes. Using a drill, drill holes and place anchors into wall. Screw in screws into anchors. Match up wall mounting bracket to screws in the wall. Make sure your mall

mount is secure before hanging your Posiflex touch screen.

Xenios LLC @2013

Page 12

4. The four metal braces are located on the back of Posiflex terminal. Place the metal bracket on the wall and secure it. Match the four terminal braces with wall mount (flat side). Slide Posiflex Touch screen onto to wall mount. Again, make sure everything is

secure before letting go of touch screen.

Xenios LLC @2013

Page 13

5. Once Posiflex screen is mounted on wall, re-connect power, and sata cables.

Xenios LLC @2013

Page 14

Recommend Documents