4060 Waterstone Installation Instructions Traditional Soap Lotion Dispenser Hook Spout

SOAP/LOTION DISPENSER INSTALLATION Contemporary Model # 4065 Traditional Model #s 4055, 4060 BEFORE YOU BEGIN YOUR INSTALLATION:

REQUIRED TOOLS:

Turn off water supply.

1.

B

Pull and remove spout (A) from dispenser body (B). Remove clamp nut (C) from threaded shroud (D).

D C

5.

3.

COUNTER OR SINK

Fit dispenser body through 1-3/8” hole on counter or sink. (No plumbers putty is required. O-ring seals base).

Insert open end of red tubing down through dispenser and into plastic bottle.

F

4.

1-3/8” HOLE

6.

G

Optional Caps - Soap, Lotion and Finish (TRADITIONAL MODELS ONLY)

Adjustable Wrench

2.

A

PARTS INCLUDED:

E

Thread the clamp nut onto threaded shroud. Tighten nut snug to underside of sink or counter.

Add soap or lotion to plastic bottle. Thread bottle (E) into bottom of dispenser shroud.

7. Push down on spout to secure over white O-rings. Pump spout a few times to get soap or lotion flowing.

Slide red tubing (F) into tube fitting (G) at bottom of spout.

41180 Raintree Court • Murrieta, CA 92562 1-888-304-0660 • 951-304-0520 www.waterstoneco.com

VEN-038-SL Rev. A