Address A0=0 DPDT Relay Port Bank 4

Relay 5-8

DPDT Relay Port Bank 4 (Port B) Address A0=1

Relay 1-4

Relay 5-8

DPDT Relay Port Bank 2 (Port B) Address A0=0

Relay 1-4 Address Jumper

I²C Pull-up Jumper (4.7K)

GND +5V

I²C Output to Next Device

SDA SCL

Relay Status LEDs

SCL SDA

Input from I²C Master

+5V GND

2.1mm Power Jack 12V DC (Center Positive) 12V DC Power Connector

I²C LED

Relay 5-8

DPDT Relay Port Bank 3 (Port A) Address A0=1

Relay 1-4 Address A0=1

CONNECTOR PINOUTS FOR 3A/5A DPDT RELAY

Relay 5-8

DPDT Relay Port Bank 1 (Port A) Address A0=0

UR Relay Rating:

Relay Warranty Rating:

Switch 2

Power LED

Address A0=0

5A@125VAC 5A@28VDC

Switch 1

Relay 1-4

5A@240VAC 5A@24VDC

NOTE: This device uses two MCP23017 I/O Expanders to control relays. Address line A0 is permanently set low on the first MCP23017. Address line A0 is permanently set high on the second MCP23017. This configuration prevents on-board I²C addressing conflicts. When chaining multiple boards on a single I²C port, address jumpers A1 and A2 must be configured to unique settings for each controller.