Advanced Exercise 6allpage
15. You determine order of machining process and depth of cuts
14. Use the Rotating Toolpath option to machine the triangular shaped pockets
13. Pocketing - rough and finish
12. Profile - rough and finish
11. Centre drilling, drilling, tapping
10. Tools as required
9. Large hole must be pre-drilled first and then use Circmill Toolpath
location. Use a centre drill .015” deep.
8. Engrave your last name in capitals on the top surface, see drawing for approximate
7. Face Mill to thickness with a 4” diameter face mill
6. Complete Job Setup – add 1/8” all around. Round up to closest 1/8”
Machining Process:
the fixture using two socket head cap screws – do not create
5. Two holes have previously been drilled and counter-bored to hold the part down on
4. Part has previously been machined to the finished thickness + 0.050”
3. Z zero is the bottom of the part
2. X0 Y0 - your choice
1. Material: Aluminium T6061
Mastercam Advanced Exercise #6 - Instructions
14. Use the Rotating Toolpath option to machine the triangular shaped pockets
13. Pocketing - rough and finish
12. Profile - rough and finish
11. Centre drilling, drilling, tapping
10. Tools as required
9. Large hole must be pre-drilled first and then use Circmill Toolpath
location. Use a centre drill .015” deep.
8. Engrave your last name in capitals on the top surface, see drawing for approximate
7. Face Mill to thickness with a 4” diameter face mill
6. Complete Job Setup – add 1/8” all around. Round up to closest 1/8”
Machining Process:
the fixture using two socket head cap screws – do not create
5. Two holes have previously been drilled and counter-bored to hold the part down on
4. Part has previously been machined to the finished thickness + 0.050”
3. Z zero is the bottom of the part
2. X0 Y0 - your choice
1. Material: Aluminium T6061
Mastercam Advanced Exercise #6 - Instructions
