aqua-mate series - Zoeller Pumps
SECTION: 2.15.030 FM2780 0315 Supersedes 0114
Your Peace of Mind is Our Top Priority ® ®
Product information presented here reflects conditions at time of publication. Consult factory regarding discrepancies or inconsistencies.
TECHNICAL DATA SHEET
AQUA-MATE SERIES
Model 72 Submersible Dewatering Pump
MATERIALS
PUMP
MOTOR
PRODUCT SPECIFICATIONS Horse Power
3/10
Voltage
115
Phase
1 Ph
Hertz
60 Hz
RPM
3400
Type
Permanent split capacitor
Insulation
Class B
Amps
3.1
Operation
Automatic or nonautomatic
Auto On/Off Points
7-3/8" (18.7 cm) / 3-5/8" (9.2 cm)
Discharge Size
1-1/2" NPT
Solids Handling
3/8" (9 mm) spherical solids
Cord Length
9' (3 m) standard
Cord Type
UL listed, 3-wire, grounded plug
Max. Head
18' (5.5 m)
Max. Flow Rate
38 GPM (144 LPM)
Max. Operating Temp.
110° F (43° C)
Cooling
Oil free
Motor Protection
Auto reset thermal overload
Motor Housing
Engineered plastic
Pump Housing
Engineered plastic
Base
Engineered plastic
Upper Bearing
Ball bearing
Lower Bearing
Ball bearing
Mechanical Seals
Carbon and ceramic
Impeller Type
Non-clogging vortex
Impeller
Engineered plastic
Hardware
Stainless steel
Motor Shaft
410 stainless steel
Gasket
Buna-N o-ring
5 15/16" (151 mm)
3 1/8" (79 mm)
4 1/4" (108 mm)
4" (102 mm)
3 1/8" (79 mm)
1 1/2" NPT
11 13/16" (300 mm)
3 3/4" (95 mm)
NOTE: See model comparison chart for specific details.
R
Certified to CSA Standard 227875
© Copyright 2015 Zoeller® Co. All rights reserved. 502-778-2731 | 800-928-7867 | 3649 Cane Run Road | Louisville, KY 40211-1961 | www.zoeller.com
SK1924
72 Gal. 38 30 14
Meters 1.5 3.0
Feet 5 10 15
4.6
Liters 144 114 53
18 ft. (5.5 m)
Shut-off Head:
FEET
PUMP PERFORMANCE CURVE MODEL 72
20
6
TOTAL DYNAMIC HEAD
MODEL
METERS
TOTAL DYNAMIC HEAD FLOW PER MINUTE
15 4 10 2 5
0 10
20
30
40
GALLONS LITERS
0
80 FLOW PER MINUTE
012051
MODEL COMPARISON
Model
Seal
Mode
Volts
Ph
Amps
HP
Hz
Lbs
Kg
Simplex
Duplex
M72
Single
Auto
115
1
3.1
3/10
60
9.5
4.3
1
3
N72
Single
Non
115
1
3.1
3/10
60
9.5
4.3
2
2&3
BN72
Single
Non
115
1
3.1
3/10
60
9.5
4.3
*
---
* Single piggyback switch included.
SELECTION GUIDE 1. Integral float-operated mechanical switch, no external control required. 2. Single piggyback variable level float switch or double piggyback variable level float switch. Refer to FM0477. 3. See FM0477 for a residential alternator system.
OPTIONAL PUMP STAND P/N 10-2421 • Reduces potential clogging by debris • Replaces rocks or bricks under the pump • Made of durable, noncorrosive ABS • Raises pump 2" (5 cm) off bottom of basin • Provides the ability to raise intake by adding sections of 1½" or 2" (DN40 or DN50) PVC piping • Attaches securely to pump • Accommodates sump, dewatering and effluent applications NOTE: Make sure float is free from obstruction.
CAUTION
"Easy assembly" (pump & discharge pipe not included.)
All installation of controls, protection devices and wiring should be done by a qualified licensed electrician. All electrical and safety codes should be followed including the most recent National Electrical Code (NEC) and the Occupational Safety and Health Act (OSHA).
© Copyright 2015 Zoeller® Co. All rights reserved. 502-778-2731 | 800-928-7867 | 3649 Cane Run Road | Louisville, KY 40211-1961 | www.zoeller.com
Your Peace of Mind is Our Top Priority ® ®
Product information presented here reflects conditions at time of publication. Consult factory regarding discrepancies or inconsistencies.
TECHNICAL DATA SHEET
AQUA-MATE SERIES
Model 72 Submersible Dewatering Pump
MATERIALS
PUMP
MOTOR
PRODUCT SPECIFICATIONS Horse Power
3/10
Voltage
115
Phase
1 Ph
Hertz
60 Hz
RPM
3400
Type
Permanent split capacitor
Insulation
Class B
Amps
3.1
Operation
Automatic or nonautomatic
Auto On/Off Points
7-3/8" (18.7 cm) / 3-5/8" (9.2 cm)
Discharge Size
1-1/2" NPT
Solids Handling
3/8" (9 mm) spherical solids
Cord Length
9' (3 m) standard
Cord Type
UL listed, 3-wire, grounded plug
Max. Head
18' (5.5 m)
Max. Flow Rate
38 GPM (144 LPM)
Max. Operating Temp.
110° F (43° C)
Cooling
Oil free
Motor Protection
Auto reset thermal overload
Motor Housing
Engineered plastic
Pump Housing
Engineered plastic
Base
Engineered plastic
Upper Bearing
Ball bearing
Lower Bearing
Ball bearing
Mechanical Seals
Carbon and ceramic
Impeller Type
Non-clogging vortex
Impeller
Engineered plastic
Hardware
Stainless steel
Motor Shaft
410 stainless steel
Gasket
Buna-N o-ring
5 15/16" (151 mm)
3 1/8" (79 mm)
4 1/4" (108 mm)
4" (102 mm)
3 1/8" (79 mm)
1 1/2" NPT
11 13/16" (300 mm)
3 3/4" (95 mm)
NOTE: See model comparison chart for specific details.
R
Certified to CSA Standard 227875
© Copyright 2015 Zoeller® Co. All rights reserved. 502-778-2731 | 800-928-7867 | 3649 Cane Run Road | Louisville, KY 40211-1961 | www.zoeller.com
SK1924
72 Gal. 38 30 14
Meters 1.5 3.0
Feet 5 10 15
4.6
Liters 144 114 53
18 ft. (5.5 m)
Shut-off Head:
FEET
PUMP PERFORMANCE CURVE MODEL 72
20
6
TOTAL DYNAMIC HEAD
MODEL
METERS
TOTAL DYNAMIC HEAD FLOW PER MINUTE
15 4 10 2 5
0 10
20
30
40
GALLONS LITERS
0
80 FLOW PER MINUTE
012051
MODEL COMPARISON
Model
Seal
Mode
Volts
Ph
Amps
HP
Hz
Lbs
Kg
Simplex
Duplex
M72
Single
Auto
115
1
3.1
3/10
60
9.5
4.3
1
3
N72
Single
Non
115
1
3.1
3/10
60
9.5
4.3
2
2&3
BN72
Single
Non
115
1
3.1
3/10
60
9.5
4.3
*
---
* Single piggyback switch included.
SELECTION GUIDE 1. Integral float-operated mechanical switch, no external control required. 2. Single piggyback variable level float switch or double piggyback variable level float switch. Refer to FM0477. 3. See FM0477 for a residential alternator system.
OPTIONAL PUMP STAND P/N 10-2421 • Reduces potential clogging by debris • Replaces rocks or bricks under the pump • Made of durable, noncorrosive ABS • Raises pump 2" (5 cm) off bottom of basin • Provides the ability to raise intake by adding sections of 1½" or 2" (DN40 or DN50) PVC piping • Attaches securely to pump • Accommodates sump, dewatering and effluent applications NOTE: Make sure float is free from obstruction.
CAUTION
"Easy assembly" (pump & discharge pipe not included.)
All installation of controls, protection devices and wiring should be done by a qualified licensed electrician. All electrical and safety codes should be followed including the most recent National Electrical Code (NEC) and the Occupational Safety and Health Act (OSHA).
© Copyright 2015 Zoeller® Co. All rights reserved. 502-778-2731 | 800-928-7867 | 3649 Cane Run Road | Louisville, KY 40211-1961 | www.zoeller.com
