Auto/Light Truck Guide Please capture the photos listed in this guide. Adjust camera resolution settings for a range between 1224x768 a d 9 x for appropriate size a d faster upload. For o ile pho es ith a + MP a era, sele t large when choosing file size. Please upload your files using the OnSource Inspector App or at www.onsourceonline.com within 3 hours of capture. BEST PRACTICE – Take more photos than needed so you are sure to capture at least one clear shot of each of the photos. Please only upload your best photo for each of the images in this guide.
Exterior Shots 1
2
Front 6
Rear/Make Model
4
3
Corner 1
Corner 2
5
Corner 3
7
8
Front Tire Tread
Rear Tire Tread
Corner 4
9
10
Roof
Engine Bay
Interior Shots 11
12
13
Odometer
Steering wheel/Dash Driver Door (options) 16
Floor – Driver Front
17
18
Floor – Driver Rear
10 Forbes Road 405W • Braintree, MA
15
14
Headliner 02184
•
Front Seats
Back Seats
19
20
Floor – Pass Front
Floor – Pass Rear
617·977·9098
•
OnSourceOnline.com
Auto/Light Truck Guide VIN/Identification 21
IMPORTANT - Capture & upload legible images of the VIN Tag and Dashboard VIN. The VIN Tag is lo ated i side the dri er’s door. If there is ore tha sti ker prese t, look for the ord VIN o the sti ker. Upload only one clear photo of each.
22
TIP - Some vehicles may be locked or out of power and access to interior, engine, odometer, and VIN may not be available. If any photos are unattainable, please capture a est a aila le photo i its pla e (for example, pictures of interiors thru the windows) and provide a reason for this in the comments section when uploading.
- PLEASE WRITE DOWN VIN & ODOMETER TO PLACE INTO COMMENTS -
Vehicle Damage Shots – Example of Front-End Damage Look for damage all over the vehicle. For each damage area please capture an overview shot of the damage and close up shots of each damaged part. Take photos from different angles, from underneath and behind damage if possible. Follo the line of impact , apturi g photos of the damaged panel as well as the two adjacent panels.
DAMAGE PHOTOS
Damage Angle #1
Damage Angle #2
Damage Angle #3
Damage Angle #4
TAPE MEASURE PHOTOS
Tape Measure (1)
Please take 2 photos with a TAPE MEASURE (with the 0-inch end on the ground) for each impact point, held straight and positioned in the center of the damage area. (1) Take an overview photo first showing the tape measure, held vertically, from the ground to above impact, and – without moving the tape measure – (2) a close-up photo with the tape measure markings visible at the point of impact.