Back Piece Front Piece Left Piece Right Piece
Right Piece Bright LED. Cut out here
Front Piece Light Sensor. Cut out here
Cut hole for Threshold knob to poke through if needed.
Apply glue and place front piece directly on top of the back piece assembly. Make sure the hole cutouts alight with the light sensor and LED modules.
Left Piece Mount circuit pieces in two rows here. Light Sensor and LED must line up with holes on front piece.
Bright LED goes here
cloudBit goes here Split bit
Glue Separator Piece Here USB Power
Light Sensor goes here
Threshold bit
Back Piece Split bit
USB Power Cord goes through this hole
Glue Side of Bottom Piece Here
Top Piece
Bottom Piece
Separator Piece
Notes: Black Boxes = Cut out here Light Gray Boxes = Mount or Glue here Dark Gray Boxes = Place specified bit module here Dotted Gray Lines = Score (lightly cut) along these lines
Front Piece Light Sensor. Cut out here
Cut hole for Threshold knob to poke through if needed.
Apply glue and place front piece directly on top of the back piece assembly. Make sure the hole cutouts alight with the light sensor and LED modules.
Left Piece Mount circuit pieces in two rows here. Light Sensor and LED must line up with holes on front piece.
Bright LED goes here
cloudBit goes here Split bit
Glue Separator Piece Here USB Power
Light Sensor goes here
Threshold bit
Back Piece Split bit
USB Power Cord goes through this hole
Glue Side of Bottom Piece Here
Top Piece
Bottom Piece
Separator Piece
Notes: Black Boxes = Cut out here Light Gray Boxes = Mount or Glue here Dark Gray Boxes = Place specified bit module here Dotted Gray Lines = Score (lightly cut) along these lines
