Machine ID # (if attached) Preventative Maintenance
3151604
18)
Is a PM due?
No
19)
If PM is due, has it been performed?
No
20)
no
21)
If PM is due and has not been performed, explain WHY. Warranty Information
22)
Overall Comments
none
416 (On File at CMCo)
(On File at CMCo)
Needs reconditioned or replaced to function properly.
Functions, but should be reconditioned or replaced.
Component functions properly.
New or recently reconditioned.
General Appearance Section 1) 2) 3) 4) 5) 6) 7)
Take a picture of hammer before disassembly Did the tool have a 2" to 4" band of grease? Take a close-up picture of tool to show absence or presence of grease Remove tool and take a picture of it before cleaning Is there tool or bushing damage due to a lack of lubricant? Has the hammer been lubricated with Cat hammer paste Sheet metal / paint
Yes Yes Yes Yes No Yes
Safety Items Section 1)
Safety decals
Operational Checks Section 1)
Check for proper operation / leaks
Operator Station / Gauges Section 1)
Gauges / switches
2)
Current O&MM safety manual
Hammer Section 1)
External housing
2)
Check for cracked welds
3)
Mounting bracket
4)
Tie rods
5)
Tool retaining pins
6)
Upper bushing
7)
Lower bushing
2
EQUIPMENT INSPECTION
Carter Machinery Company, Inc.
Hammer Section 8)
Front-to-rear bushing diameter
9)
Side-to-side bushing diameter
10)
Lower seal
11)
Check piston face
Tool Bit Section 1)
Part number
1883503
2)
Cost
710.00
3)
Diameter
4)
Length
5)
Inspect and debur pin slots
6)
Inspect for heavy
7)
Tool bit wear charge
29 7/8IN
35.00 PER INCH
Hydraulics Section 1)
Hose / hose armor
2)
Fittings / quick disconnects
3)
Clean and Plug Hydraulic Lines Together
Yes
Fluid Levels / Checks Section 1) 2)
Grease all fittings using CAT hammer paste Check for leaks