Casio Exilim EX-Z70 Lens Replacement

Report 1 Downloads 75 Views
Casio Exilim EX-Z70 Lens Replacement

Casio Exilim EX-Z70 Lens Replacement Use this quide to replace or install the lens on your camera

Written By: Dylan Fuller

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 6

Casio Exilim EX-Z70 Lens Replacement

TOOLS: Tweezers (1) Phillips #0 Screwdriver (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 6

Casio Exilim EX-Z70 Lens Replacement

Step 1 — Lens



Use a pair of tweezers to gently move the wire away from the lens



This will make the area around the lens easily accessible

Step 2



The lens is held in by two hooks, one in the upper left hand corner and another in the lower right



Using a screwdriver push the metal hooks on the upper left corner, underneath the edge of circuit board. Pull up on the upper left corner of the lens, freeing the corner from the camera casing.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 6

Casio Exilim EX-Z70 Lens Replacement

Step 3



While pulling the lens up out of the casing, push the hook to the lower right corner of the lens out of the way.



At this point the lens should be connected to the camera solely by two orange plastic strips.

Step 4



Using tweezers or finger nails pull up the brown flaps where the two orange film strips connected to the lens meets the circuit board.



Use tweezers to pull the orange film strips out of the port. It should come out easily.

 There are two additional film strips connected to the circuit board that do not need to be removed. These are connected to the opposite side of the circuit board than the lens. © iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 6

Casio Exilim EX-Z70 Lens Replacement

Step 5



Completely remove the lens. There should not be anything else holding it in place.

Step 6



Turn the lens over



On the back are four screws. Remove the two silver screws (4.36 mm) from the back of the lens.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 5 of 6

Casio Exilim EX-Z70 Lens Replacement

Step 7 

Remove the loose piece from the back of the lens and set it aside



The lens is now ready to be replaced with a new one.

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-23 04:25:14 AM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 6 of 6