DeWalt DW660 Collet Replacement

DeWalt DW660 Collet Replacement

DeWalt DW660 Collet Replacement Use this guide to replace the collet on your DeWalt DW660.

Written By: AL25

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 5

DeWalt DW660 Collet Replacement

INTRODUCTION The DW660 uses a tool-free bit change mechanism, which involves two grips: one locks the motor shaft in place, while the other allows the user to rotate the collet nut independently of the motor shaft.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 5

DeWalt DW660 Collet Replacement

Step 1 — Collet 

Remove the depth guide from the top of the tool.



Press and hold down lock button #1.

Step 2

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 5

DeWalt DW660 Collet Replacement

Step 3



Press lock button #2 while still holding lock button #1.



Rotate lock button #2 counterclockwise until you see the collet nut become loose.

Step 4



Remove the large collet nut.



Remove the collet.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 5

DeWalt DW660 Collet Replacement

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-22 06:58:14 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 5 of 5