Disassembling Olympus Stylus 725 SW Back Panel
Disassembling Olympus Stylus 725 SW Back Panel
Disassembling Olympus Stylus 725 SW Back Panel Written By: Bobby Hodges
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 5
Disassembling Olympus Stylus 725 SW Back Panel
INTRODUCTION Use this guide to remove the back panel to access the components inside.
TOOLS: Phillips #00 Screwdriver (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 5
Disassembling Olympus Stylus 725 SW Back Panel
Step 1 — Battery
The battery is located on the buttom of the camera.
Remove the battery by placing your thumb on the buttom flap and sliding the release button away from the side the lens is on. (The screwdriver is simply used as a reference point, no screws need to be removed)
For a dead battery, charge the battery for 60-90 minutes.
When installing a charged battery, align the battery appropriately, with the positive signs and negative signs lining up.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 5
Disassembling Olympus Stylus 725 SW Back Panel
Step 2 — Back Panel
Unscrew the 3mm long cover screws at the corners of the camera using a #00 Philips Screwdriver.
Unscrew the 2mm long screws securing the sides of the camera which holds the back panel. Use the same screwdriver.
Step 3
Be careful when removing the back cover, you will need to detach the connecting ribbons
Detach the ribbons using your thumb, sliding them out of their slots.
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-17 05:14:54 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 5
Disassembling Olympus Stylus 725 SW Back Panel
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 5 of 5
Disassembling Olympus Stylus 725 SW Back Panel Written By: Bobby Hodges
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 5
Disassembling Olympus Stylus 725 SW Back Panel
INTRODUCTION Use this guide to remove the back panel to access the components inside.
TOOLS: Phillips #00 Screwdriver (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 5
Disassembling Olympus Stylus 725 SW Back Panel
Step 1 — Battery
The battery is located on the buttom of the camera.
Remove the battery by placing your thumb on the buttom flap and sliding the release button away from the side the lens is on. (The screwdriver is simply used as a reference point, no screws need to be removed)
For a dead battery, charge the battery for 60-90 minutes.
When installing a charged battery, align the battery appropriately, with the positive signs and negative signs lining up.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 5
Disassembling Olympus Stylus 725 SW Back Panel
Step 2 — Back Panel
Unscrew the 3mm long cover screws at the corners of the camera using a #00 Philips Screwdriver.
Unscrew the 2mm long screws securing the sides of the camera which holds the back panel. Use the same screwdriver.
Step 3
Be careful when removing the back cover, you will need to detach the connecting ribbons
Detach the ribbons using your thumb, sliding them out of their slots.
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-17 05:14:54 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 5
Disassembling Olympus Stylus 725 SW Back Panel
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 5 of 5
