Display Set-Up - Displays2go
Display Set-Up Step 1
Step 2
Take out all parts and place them on a clean surface. Connect the Top Bar (1) to both Curved Vertical Bars (3) by sliding the Top Bar (1) into the long end of the Curved Vertical Bar (3) until the release button on the Top Bar (1) snaps into the 1st hole on the Curved Vertical Bar.
Leave release button in the first hole for an 8 foot table. If sizing for a 6 foot table, press in the release button and continue sliding the Top Bar (1) until the release button snaps into the 2nd hole.
Release button in 1st hole for 8' Table
Release button in 2nd hole for 6' Table
Step 3
Step 4
Connect both Vertical Bars w/Clamps (2) to the ends of the Curved Vertical Bars (3) by sliding on to the recessed end of the Curved Vertical Bars (3).
With two people, lift the assembled Over the Top Frame and slide the clamps onto the top of your table.
Fully assembled frame Slide clamps into place
Step 5
Step 6
When both Clamps are positioned in your desired location, turn the bolt on the bottom of the clamps to secure the frame to your table.
Leave your frame in this position for the lower 6' height setting. If you are displaying a Tall Backwall at the 8' height setting, with two people, press the release button on both Vertical Bars w/Clamps (2) and simultaneously pull both of the Vertical bars up, until the release button clicks to secure the bars into place.
Step 7 Slide your graphic over the top of the frame.
Instructions Continued On Back Side
3/12
Step 2
Take out all parts and place them on a clean surface. Connect the Top Bar (1) to both Curved Vertical Bars (3) by sliding the Top Bar (1) into the long end of the Curved Vertical Bar (3) until the release button on the Top Bar (1) snaps into the 1st hole on the Curved Vertical Bar.
Leave release button in the first hole for an 8 foot table. If sizing for a 6 foot table, press in the release button and continue sliding the Top Bar (1) until the release button snaps into the 2nd hole.
Release button in 1st hole for 8' Table
Release button in 2nd hole for 6' Table
Step 3
Step 4
Connect both Vertical Bars w/Clamps (2) to the ends of the Curved Vertical Bars (3) by sliding on to the recessed end of the Curved Vertical Bars (3).
With two people, lift the assembled Over the Top Frame and slide the clamps onto the top of your table.
Fully assembled frame Slide clamps into place
Step 5
Step 6
When both Clamps are positioned in your desired location, turn the bolt on the bottom of the clamps to secure the frame to your table.
Leave your frame in this position for the lower 6' height setting. If you are displaying a Tall Backwall at the 8' height setting, with two people, press the release button on both Vertical Bars w/Clamps (2) and simultaneously pull both of the Vertical bars up, until the release button clicks to secure the bars into place.
Step 7 Slide your graphic over the top of the frame.
Instructions Continued On Back Side
3/12
