DS9447 Remote LCD Keypad AWS

Report 0 Downloads 131 Views
Fire Alarm Systems | DS9447 Remote LCD Keypad

DS9447 Remote LCD Keypad ▶ Compatible with the DS9400M/AddressiFire 255 and DS9400i Fire Alarm Control Panels ▶ 2-line, 32-character alphanumeric LCD display ▶ Status LEDs identify Alarm, Trouble, Power and Silenced conditions ▶ Easy addressing via jumper pins ▶ Permits remote control of system, including commands and programming ▶ Passcode protection controls system access ▶ Low profile design

The DS9447 Remote LCD Keypad is a 4-wire alphanumeric keypad that combines system annunciator and controller functions. It operates identically to the built-in user interface on the DS9400M/AddressiFire and DS9400i Fire Alarm Control Panels. Access to control functions is passcode protected, allowing for installation in areas available to the general public. It connects to the control panel’s option bus.

• •

Do not exceed 305 m (1000 ft) between the control panel and the remote keypads. Do not exceed the total amount of keypad wiring permitted per system which is limited to a maximum of 1219 m (4000 ft.).

Number of keypads Up to two keypads may be placed along any single 305 m (1000 ft.) run of 0.8 mm (#22 AWG) wire. Three keypads may be used on any single 305 m (1000 ft.) run of 1.2 mm (#18 AWG) wire.

Certifications and Approvals Technical Specifications

Region

Certification

USA

UL

UOXX: Control Unit Accessories, System (UL864)

Compatible Control Panels:

NYC-MEA

12-92-E, Vol. VII

Enclosure Design Dimensions (HxWxD):

Installation/Configuration Notes Wiring Guidelines • Keypad wiring can not be shared with multiplex, options bus, telephone, or siren wiring. • Use a minimum of 0.8 mm (#22 AWG) 4-wire cable; but do not use twisted pair or shielded cable. Note

DS9400M and DS9400i Series Fire Alarm Control Panels 12 cm x 16 cm x 3 cm (4.6 in. x 6.3 in. x 1.2 in.)

Environmental Considerations Relative Humidity:

5% to 85% @ +30°C (+86°F), non-condensing

Temperature (Operating):

0°C to +49°C (+32°F to +120°F)

1.2 mm (#18 AWG) cable is required for NEC‑NFPA‑72.

www.boschsecurity.com

2 | DS9447 Remote LCD Keypad

Compatible Control Panels:

DS9400M and DS9400i Series Fire Alarm Control Panels

Maximum Number of Units:

Up to four DS9447 keypads allowed per DS9400 Series system

Power Requirements Current (Alarm):

100 mA (use 75 mA for battery calculations)

Current (Standby):

100 mA (use 75 mA for battery calculations)

Ordering Information DS9447 Remote LCD Keypad Replaced by D7033.

Americas: Bosch Security Systems, Inc. 130 Perinton Parkway Fairport, New York, 14450, USA Phone: +1 800 289 0096 Fax: +1 585 223 9180 [email protected] www.boschsecurity.us

DS9447

Europe, Middle East, Africa: Bosch Security Systems B.V. P.O. Box 80002 5600 JB Eindhoven, The Netherlands Phone: + 31 40 2577 284 Fax: +31 40 2577 330 [email protected] www.boschsecurity.com

© Bosch Security Systems Inc. 2010 | Data subject to change without notice T1119356811 | Cur: en-US, V4, 4 Jul 2010

Asia-Pacific: Represented by Robert Bosch (SEA) Pte Ltd, Security Systems 11 Bishan Street 21 Singapore 573943 Phone: +65 6258 5511 Fax: +65 6571 2698 [email protected] www.boschsecurity.com