Embroidery Club February 2014 USB Flash Drive Holders* Supply List
Embroidery Club February 2014 USB Flash Drive Holders*
Supply List *They also work great for lipstick! • • • • • • • • • • •
•
•
Embroidery Machine with feet and attachments for embroidery only 100x100mm (4x4) embroidery hoop KK2000 Scissors for cutting paper Scissors for cutting fabric Small scissors for cutting thread Pins Rotary cutter and ruler Marker for tracing pattern onto stabilizer Bobbins: one wound with bobbin thread and one wound with embroidery thread for stitching border Floriani Poly embroidery thread: I used medium green for vine, two shades of gold for flower petals, very pale yellow for flower center, and dark olive green for border. Your border thread should match your fabric Stabilizer: You will need Floriani Wet n Gone, or other ‘fabric’ type water soluble stabilizer. Make sure it is the fabric type; the clear topping water soluble will not work. Fabric: You will need a non-fraying fabric such as felt or faux suede. The thinner craft felt will work just fine for this project. You will need an 8x10 inch piece. (The pre-cut size for the craft felt will make a couple of USB holders)
Alternate USB holder (the double USB pictured on right)
• •
Stabilizer and notion requirements are the same as above Embroidery thread: I used bright green for leaves and vines, medium yellow for flower centers, orange for flower petals, and dark rust for the outline. You will also need one color to match your fabric and a bobbin wound with the matching thread
Fabrics: • • • •
100% cotton solid for front, one 6”x4” rectangle 100% cotton coordinating print for back-- one 8”x4” rectangle 100% cotton coordinating print for fold over pocket-- one 11”x4” rectangle One 4”x20” strip Pellon 911ff fusible interfacing
Supply List *They also work great for lipstick! • • • • • • • • • • •
•
•
Embroidery Machine with feet and attachments for embroidery only 100x100mm (4x4) embroidery hoop KK2000 Scissors for cutting paper Scissors for cutting fabric Small scissors for cutting thread Pins Rotary cutter and ruler Marker for tracing pattern onto stabilizer Bobbins: one wound with bobbin thread and one wound with embroidery thread for stitching border Floriani Poly embroidery thread: I used medium green for vine, two shades of gold for flower petals, very pale yellow for flower center, and dark olive green for border. Your border thread should match your fabric Stabilizer: You will need Floriani Wet n Gone, or other ‘fabric’ type water soluble stabilizer. Make sure it is the fabric type; the clear topping water soluble will not work. Fabric: You will need a non-fraying fabric such as felt or faux suede. The thinner craft felt will work just fine for this project. You will need an 8x10 inch piece. (The pre-cut size for the craft felt will make a couple of USB holders)
Alternate USB holder (the double USB pictured on right)
• •
Stabilizer and notion requirements are the same as above Embroidery thread: I used bright green for leaves and vines, medium yellow for flower centers, orange for flower petals, and dark rust for the outline. You will also need one color to match your fabric and a bobbin wound with the matching thread
Fabrics: • • • •
100% cotton solid for front, one 6”x4” rectangle 100% cotton coordinating print for back-- one 8”x4” rectangle 100% cotton coordinating print for fold over pocket-- one 11”x4” rectangle One 4”x20” strip Pellon 911ff fusible interfacing
