Fujifilm Endeavor 100ix Battery Door Replacement

Fujifilm Endeavor 100ix Battery Door Replacement

Fujifilm Endeavor 100ix Battery Door Replacement Replace the Battery Door in your Fujifilm Endeavor 100ix.

Written By: Eric Nicolai

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 6

Fujifilm Endeavor 100ix Battery Door Replacement

INTRODUCTION Use this guide to replace the battery door.

TOOLS: Phillips #00 Screwdriver (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 6

Fujifilm Endeavor 100ix Battery Door Replacement

Step 1 — Battery Door 

Locate and remove two 6.4mm screws on the bottom of the camera with a Phillips #00 screwdriver.



Locate the battery door.

Step 2

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 6

Fujifilm Endeavor 100ix Battery Door Replacement

Step 3 

Locate the latch on the battery door.



Use your finger pry to it open where it says "BATT."



Remove the battery from the camera by pulling the battery door outward.

Step 4

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 6

Fujifilm Endeavor 100ix Battery Door Replacement

Step 5 

Locate and remove three black 3.80mm screws on the back of the black casing with the Phillips #00 screwdriver.



Squeeze the camera placing a thumb on the tab marked CE.



Pull the back half of the camera firmly away from the camera body.

Step 6

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 5 of 6

Fujifilm Endeavor 100ix Battery Door Replacement

Step 7



Locate and remove the 3.80mm screw that holds the plastic strip to the camera body with a Phillips #00 screwdriver.



The plastic strip will now come off the camera body.

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-18 02:27:48 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 6 of 6