Graco Literider Classic Connect Handle Cover Replacement
Graco Literider Classic Connect Handle Cover Replacement
Graco Literider Classic Connect Handle Cover Replacement This guide will show you how to remove the handle cover.
Written By: Tyler Laird
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
Graco Literider Classic Connect Handle Cover Replacement
INTRODUCTION This guide shows how to locate the screws on the handle cover and remove them to allow the handle cover to come off. This is only necessary if there is a problem in collapsing the stroller.
TOOLS: Phillips #1 Screwdriver (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
Graco Literider Classic Connect Handle Cover Replacement
Step 1 — Handle Cover
Flip the stroller over so that the screws on the handle are facing upwards.
Locate the four 22 mm Phillips screws on the underside of the handle.
Using a Phillips #1 screwdriver, remove the four 22 mm screws and set them aside.
Step 2
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 4
Graco Literider Classic Connect Handle Cover Replacement
Step 3
Push the switch in to allow the handle cover to come free.
Remove the handle cover from the handle.
Step 4
Avoid pushing the two rods fully into the slots on the handle, as they can be very difficult to remove.
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-07-08 09:32:17 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
Graco Literider Classic Connect Handle Cover Replacement This guide will show you how to remove the handle cover.
Written By: Tyler Laird
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
Graco Literider Classic Connect Handle Cover Replacement
INTRODUCTION This guide shows how to locate the screws on the handle cover and remove them to allow the handle cover to come off. This is only necessary if there is a problem in collapsing the stroller.
TOOLS: Phillips #1 Screwdriver (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
Graco Literider Classic Connect Handle Cover Replacement
Step 1 — Handle Cover
Flip the stroller over so that the screws on the handle are facing upwards.
Locate the four 22 mm Phillips screws on the underside of the handle.
Using a Phillips #1 screwdriver, remove the four 22 mm screws and set them aside.
Step 2
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 4
Graco Literider Classic Connect Handle Cover Replacement
Step 3
Push the switch in to allow the handle cover to come free.
Remove the handle cover from the handle.
Step 4
Avoid pushing the two rods fully into the slots on the handle, as they can be very difficult to remove.
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-07-08 09:32:17 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
