HP EliteOne 800 G1 Removing Stand Replacement

HP EliteOne 800 G1 Removing Stand Replacement

HP EliteOne 800 G1 Removing Stand Replacement Prerequisite Only

Written By: Michael Ewing

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 4

HP EliteOne 800 G1 Removing Stand Replacement

INTRODUCTION Prerequisite Only

TOOLS: T15 Torx Screwdriver (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 4

HP EliteOne 800 G1 Removing Stand Replacement

Step 1 — Removing Stand



Press locking latch on the bottom of the base of the stand.



Pull the plastic cover off of the stand.

Step 2



Use a Torx T15 driver and stick it through the holes on the stand in order to remove the two 12mm screws on the back of the main unit.



Tilt stand and lift up to remove it.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 4

HP EliteOne 800 G1 Removing Stand Replacement

Step 3



Use a Torx T15 driver to remove the single 10mm screw on the back panel.



Pull the back panel toward the bottom of the device to remove it.

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-21 07:21:02 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 4