HTC Desire 510 Touch screen Glass and/or LCD Display
HTC Desire 510 Touch screen Glass and/or LCD Display
HTC Desire 510 Touch screen Glass and/or LCD Display HTC Desire 510 Touch screen Glass and/or LCD Display
Written By: ZFix
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 8
HTC Desire 510 Touch screen Glass and/or LCD Display
INTRODUCTION HTC Desire 510 / RIO - How to replace broken, not working Digitizer glass and/or LCD Display.
[video: https://www.youtube.com/watch?v=xP50fhhL-B8]
TOOLS: iFixit Opening Tools (1) Spudger (1) T5 Torx Screwdriver (1) Tweezers (1) Heat Gun (1) adhesive tape 3 mm (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 8
HTC Desire 510 Touch screen Glass and/or LCD Display
Step 1 — BATTERY REMOVAL
Switch off the phone, remove the battery and any installed SIM and memory cards.
Remove 7x Torx T5 screws.
Step 2 — REAR BEZEL REMOVAL
Use a plastic tool to remove the rear bezel.
The loudspeaker is on the inner side of the rear bezel.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 8
HTC Desire 510 Touch screen Glass and/or LCD Display
Step 3 — FLEX CABLES DISCONNECTING
Disconnect the touch screen flex cable.
Disconnect the light sensor flex cable.
Unstuck the vibra-motor from the middle frame.
Remove the coaxial antenna cable from the middle frame.
The LCD display flex cable is connected to the bottom side of the board. Step 4 — LOGIC BOARD REMOVAL
At the upper left side, the board is held by a plastic locking clip. Use a plastic tool and start the separating from here.
Gently disconnect the LCD display flex cable.
Now remove the logic board.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 8
HTC Desire 510 Touch screen Glass and/or LCD Display
Step 5 — PREPARATION THE GLASS
Put a scotch tape to prevent the glass from scattering.
Use a hot gun or hair dryer and warm the glass. This will make the adhesive soften and the separation easier.
Step 6 — SEPARATION THE GLASS
Use a cutter and slightly lift the glass in one of the corners. When you make enough room, put a plastic tool.
Continue the separating with plastic tools to prevent the middle frame from scratches.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 5 of 8
HTC Desire 510 Touch screen Glass and/or LCD Display
Step 7 — SEPARATION THE GLASS (2)
The digitizer flex cable goes under the LCD display.
Slightly lift the display and unstuck the digitizer ribbon cable from the from the rear side of the display.
Step 8 — LCD DISPLAY
If you have a broken LCD display, use a plastic tool and remove it from the middle frame.
It's not glued to the frame.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 6 of 8
HTC Desire 510 Touch screen Glass and/or LCD Display
Step 9 — INSTALLING THE NEW SPARE PART
Install a new adhesive tape on the digitizer glass.
First put the touch screen flex cable in the right hole and then install the LCD Display.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 7 of 8
HTC Desire 510 Touch screen Glass and/or LCD Display
Step 10 — REASSEMBLING
Now is time to reassemble the phone.
That's all.
.
.
.
.
Did you do it successfully?
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-21 07:22:08 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 8 of 8
HTC Desire 510 Touch screen Glass and/or LCD Display HTC Desire 510 Touch screen Glass and/or LCD Display
Written By: ZFix
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 8
HTC Desire 510 Touch screen Glass and/or LCD Display
INTRODUCTION HTC Desire 510 / RIO - How to replace broken, not working Digitizer glass and/or LCD Display.
[video: https://www.youtube.com/watch?v=xP50fhhL-B8]
TOOLS: iFixit Opening Tools (1) Spudger (1) T5 Torx Screwdriver (1) Tweezers (1) Heat Gun (1) adhesive tape 3 mm (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 8
HTC Desire 510 Touch screen Glass and/or LCD Display
Step 1 — BATTERY REMOVAL
Switch off the phone, remove the battery and any installed SIM and memory cards.
Remove 7x Torx T5 screws.
Step 2 — REAR BEZEL REMOVAL
Use a plastic tool to remove the rear bezel.
The loudspeaker is on the inner side of the rear bezel.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 8
HTC Desire 510 Touch screen Glass and/or LCD Display
Step 3 — FLEX CABLES DISCONNECTING
Disconnect the touch screen flex cable.
Disconnect the light sensor flex cable.
Unstuck the vibra-motor from the middle frame.
Remove the coaxial antenna cable from the middle frame.
The LCD display flex cable is connected to the bottom side of the board. Step 4 — LOGIC BOARD REMOVAL
At the upper left side, the board is held by a plastic locking clip. Use a plastic tool and start the separating from here.
Gently disconnect the LCD display flex cable.
Now remove the logic board.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 8
HTC Desire 510 Touch screen Glass and/or LCD Display
Step 5 — PREPARATION THE GLASS
Put a scotch tape to prevent the glass from scattering.
Use a hot gun or hair dryer and warm the glass. This will make the adhesive soften and the separation easier.
Step 6 — SEPARATION THE GLASS
Use a cutter and slightly lift the glass in one of the corners. When you make enough room, put a plastic tool.
Continue the separating with plastic tools to prevent the middle frame from scratches.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 5 of 8
HTC Desire 510 Touch screen Glass and/or LCD Display
Step 7 — SEPARATION THE GLASS (2)
The digitizer flex cable goes under the LCD display.
Slightly lift the display and unstuck the digitizer ribbon cable from the from the rear side of the display.
Step 8 — LCD DISPLAY
If you have a broken LCD display, use a plastic tool and remove it from the middle frame.
It's not glued to the frame.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 6 of 8
HTC Desire 510 Touch screen Glass and/or LCD Display
Step 9 — INSTALLING THE NEW SPARE PART
Install a new adhesive tape on the digitizer glass.
First put the touch screen flex cable in the right hole and then install the LCD Display.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 7 of 8
HTC Desire 510 Touch screen Glass and/or LCD Display
Step 10 — REASSEMBLING
Now is time to reassemble the phone.
That's all.
.
.
.
.
Did you do it successfully?
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-21 07:22:08 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 8 of 8
