installation instructions :dedeen sloot - SupplyHouse.com

Report 3 Downloads 26 Views
INSTALLATION INSTRUCTIONS TOOLS NEEDED:

DO NOT USE:

For toilet base with four holes, screws are used in the front two holes. 1. Line up toilet bowl base. Through front two holes on base, carefully drill 3/16" pilot/starter holes in floor. 2. Insert screws. Place brass washers, then closed-end nuts over screws. 3. Tighten nuts carefully with wrench. DO NOT OVERTIGHTEN or bowl may crack.

CLOSED-END NUT BRASS WASHER

TOILET BOWL SCREW

For toilet base with four holes, toilet bowl bolts are used in the back two holes to secure bowl to floor flange (use Fluidmaster Model 7111). If new bolt caps are needed, use Fluidmaster Model 7115 or 7116.

© 2011 Fluidmaster, Inc. All rights reserved. This document is not a substitute for the product instructions, which may be found at www.fluidmaster.com. Fluidmaster, Inc. shall not be liable for any damages resulting from failure to install or maintain the product in accordance with the product instructions, from abuse or misuse of the product, from use of non-Fluidmaster, Inc. parts, or from overtightening. Do not use in-tank drop-in toilet bowl cleaners containing bleach or chlorine.

®

30800 Rancho Viejo Road San Juan Capistrano, CA 92675 U.S.A.

www.fixthistoilet.com