Installation Instructions - GE Appliances Store
Installation Instructions
Filter Replacement GXRTDR
Your new GE icemaker water filter comes complete with all the necessary hardware for installation. Each filter gives you up to six months of great-tasting water. Filter should be changed after 6 months of use. REQUIRED TOOLS FOR INSTALLATION
OPTIONAL TOOLS FOR INSTALLATION
• a tube cutter • a knife • a bucket or pan
• a file • sandpaper System is Tested and Certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor and Particulate Class V.
Do not use where water is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
WARNING
Small parts remaining after the installation could be a choke hazard. Discard safely.
The GXRTDR has been tested and Certified by WQA according to CSA B483.1.
SPECIFICATIONS • This System has been tested according to NSF/ANSI 42 for reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42. • Actual performance may vary with local water conditions. Model GXRTDR
Service Flow rate
Service Life
Pressure
Max. Temp.
0.5 gpm (1.9 lpm)
2500 gal. (9463 liters) or 6 months
25–125 psi (172–862 kPa)
100°F (38°C)
Tested % Reduction Influent Challenge Contaminant % Reduction Required Concn. Required
Average Influent
Average Effluent
Chlorine
70%
≥50%
2.0 mg/L ± 10%
2.0 mg/L 0.59 mg/L
Particulate, Class V particles 30 to
Filter Replacement GXRTDR
Your new GE icemaker water filter comes complete with all the necessary hardware for installation. Each filter gives you up to six months of great-tasting water. Filter should be changed after 6 months of use. REQUIRED TOOLS FOR INSTALLATION
OPTIONAL TOOLS FOR INSTALLATION
• a tube cutter • a knife • a bucket or pan
• a file • sandpaper System is Tested and Certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor and Particulate Class V.
Do not use where water is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
WARNING
Small parts remaining after the installation could be a choke hazard. Discard safely.
The GXRTDR has been tested and Certified by WQA according to CSA B483.1.
SPECIFICATIONS • This System has been tested according to NSF/ANSI 42 for reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42. • Actual performance may vary with local water conditions. Model GXRTDR
Service Flow rate
Service Life
Pressure
Max. Temp.
0.5 gpm (1.9 lpm)
2500 gal. (9463 liters) or 6 months
25–125 psi (172–862 kPa)
100°F (38°C)
Tested % Reduction Influent Challenge Contaminant % Reduction Required Concn. Required
Average Influent
Average Effluent
Chlorine
70%
≥50%
2.0 mg/L ± 10%
2.0 mg/L 0.59 mg/L
Particulate, Class V particles 30 to
