ION Linear Bluetooth QSG

How to Program the Scanner 1. 2. 3.

No Terminator

Scan the Start Configuration barcode. Scan all necessary configuration codes to configure the scanner. Scan the End Configuration barcode to save the changes.

NOTE: All settings marked with * are default settings.

Start Configuration

Connection Instructions Configure Bluetooth Settings

End Configuration Enable SPP Communication

Resetting the Scanner Scan the Default Settings barcode to reset the scanner back to the factory defaults.

Disconnect Previous Setting

Default Settings

Scan the barcode under the base

Terminator Settings

Repair

A terminator is a command that is transmitted after the barcode is scanned. To set the terminator, scan one of the barcodes below.

ION Linear Bluetooth

*Carriage Return Terminator Save SPP Settings

Tab Terminator

End Bluetooth Configuration

Sleep Settings

Disable

Beep Settings NOTE: No configuration barcodes are required for these settings.

NOTE: No configuration barcodes are required for these settings.

5 Minutes

Off

UPC-E Settings *10 Minutes

Truncate Leading Zero

*On

The Truncate Leading Zero setting configures the scanner to not transmit the zero at the beginning of the barcode.

Enable 30 Minutes

Sample Barcodes UPC-A Settings

*Disable

UPC-A

Truncate Leading Zero The Truncate Leading Zero setting configures the scanner to not transmit the zero at the beginning of the barcode.

UPC-E

Enable

Check Digit Send The Check Digit setting configures the scanner to not transmit the last character of a barcode.

*Disable

Check Digit Send

*Enable

Disable

EAN-13

Code 39

The Check Digit setting configures the scanner to not transmit the last character of a barcode.

*Enable

Code 128