iPod Shuffle 3rd Generation Headphone Jack & Shuffle Switch ...
iPod Shuffle 3rd Generation Headphone Jack & Shuffle Switch Replacement
iPod Shuffle 3rd Generation Headphone Jack & Shuffle Switch Replacement Headphone jack and shuffle switch replacement.
Written By: Matt Newsom
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 7
iPod Shuffle 3rd Generation Headphone Jack & Shuffle Switch Replacement
INTRODUCTION Replace the damaged headphone jack to hear those sweet tunes again.
TOOLS: Metal Spudger (1) Phillips #000 Screwdriver (1) iFixit Opening Tools (1) Spudger (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 7
iPod Shuffle 3rd Generation Headphone Jack & Shuffle Switch Replacement
Step 1 — Rear Case
Widen the small gap between the front and rear case by inserting a metal spudger into the gap near the top of the iPod.
Be careful when using a metal spudger, as you may scratch the outer case.
Step 2
Insert an iPod opening tool into the newly widened gap, and pry the rear case up and away from the front case.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 7
iPod Shuffle 3rd Generation Headphone Jack & Shuffle Switch Replacement
Step 3
Insert the iPod Shuffle opening tool into the gap between the front and rear case on the same side, at the bottom corner of the iPod.
Pry the rear case away from the front case.
Lift the bottom of the rear case and remove it from the rest of the iPod.
Step 4
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 7
iPod Shuffle 3rd Generation Headphone Jack & Shuffle Switch Replacement
Step 5 — Logic Board
Disconnect the headphone jack and shuffle switch connector by prying it off the logic board with a spudger.
Remove the single Phillips screw securing the logic board to the front case.
Step 6
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 5 of 7
iPod Shuffle 3rd Generation Headphone Jack & Shuffle Switch Replacement
Step 7
Peel the battery up from the front case with an iPod opening tool.
Remove the logic board and battery from the iPod.
Pry the headphone jack from the front case with an iPod opening tool.
Step 8 — Headphone Jack & Shuffle Switch
Don't attempt to remove the headphone jack yet, it is connected to the shuffle switch.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 6 of 7
iPod Shuffle 3rd Generation Headphone Jack & Shuffle Switch Replacement
Step 9
Using the pointed tip of a spudger, push the shuffle switch in to separate it from the front case.
Remove the headphone jack and shuffle switch from the front case.
Step 10
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-17 05:28:04 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 7 of 7
iPod Shuffle 3rd Generation Headphone Jack & Shuffle Switch Replacement Headphone jack and shuffle switch replacement.
Written By: Matt Newsom
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 7
iPod Shuffle 3rd Generation Headphone Jack & Shuffle Switch Replacement
INTRODUCTION Replace the damaged headphone jack to hear those sweet tunes again.
TOOLS: Metal Spudger (1) Phillips #000 Screwdriver (1) iFixit Opening Tools (1) Spudger (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 7
iPod Shuffle 3rd Generation Headphone Jack & Shuffle Switch Replacement
Step 1 — Rear Case
Widen the small gap between the front and rear case by inserting a metal spudger into the gap near the top of the iPod.
Be careful when using a metal spudger, as you may scratch the outer case.
Step 2
Insert an iPod opening tool into the newly widened gap, and pry the rear case up and away from the front case.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 7
iPod Shuffle 3rd Generation Headphone Jack & Shuffle Switch Replacement
Step 3
Insert the iPod Shuffle opening tool into the gap between the front and rear case on the same side, at the bottom corner of the iPod.
Pry the rear case away from the front case.
Lift the bottom of the rear case and remove it from the rest of the iPod.
Step 4
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 7
iPod Shuffle 3rd Generation Headphone Jack & Shuffle Switch Replacement
Step 5 — Logic Board
Disconnect the headphone jack and shuffle switch connector by prying it off the logic board with a spudger.
Remove the single Phillips screw securing the logic board to the front case.
Step 6
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 5 of 7
iPod Shuffle 3rd Generation Headphone Jack & Shuffle Switch Replacement
Step 7
Peel the battery up from the front case with an iPod opening tool.
Remove the logic board and battery from the iPod.
Pry the headphone jack from the front case with an iPod opening tool.
Step 8 — Headphone Jack & Shuffle Switch
Don't attempt to remove the headphone jack yet, it is connected to the shuffle switch.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 6 of 7
iPod Shuffle 3rd Generation Headphone Jack & Shuffle Switch Replacement
Step 9
Using the pointed tip of a spudger, push the shuffle switch in to separate it from the front case.
Remove the headphone jack and shuffle switch from the front case.
Step 10
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-17 05:28:04 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 7 of 7
