iPod Touch 4th Generation speaker soldering

iPod Touch 4th Generation speaker soldering

iPod Touch 4th Generation speaker soldering iPod Touch Logic Board soldering points

Written By: Tysl332

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 3

iPod Touch 4th Generation speaker soldering

INTRODUCTION This guide will help you in identifying the soldering joints locations for the loud speaker on the iPod Touch 4th Generation

TOOLS:

PARTS:

Soldering Station (1)

iPodTouch 4th Generation Loud Speaker replacemnt (1)

Solder (1) Desoldering Braid (1) Flush Wire Cutters (1) to strip the wires, of existing loud speaker unless you've got a replacement

Solder Vacuum (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 3

iPod Touch 4th Generation speaker soldering

Step 1 — iPod Touch 4th Generation speaker soldering



I've boxed where the ribbon cable connectors go for the screen and camera.



The soldering joints are marked with a Blue and a Red dot to indicate where to solder the speaker wires. 



The second picture shows the wires soldered to the logic board.

The loud speaker replacement was very tedious job.. anyways Good Luck

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-20 03:29:54 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 3