iRobot Roomba 655 Pet Series Front Bumper Replacement
iRobot Roomba 655 Pet Series Front Bumper Replacement
iRobot Roomba 655 Pet Series Front Bumper Replacement How to remove the front bumper on your Roomba
Written By: Rhett
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
iRobot Roomba 655 Pet Series Front Bumper Replacement
INTRODUCTION You will be removing the front bumper (this runs into objects and walls) from the Roomba in order to gain access to things like the control center (display) and motherboard.
TOOLS: Phillips #1 Screwdriver (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
iRobot Roomba 655 Pet Series Front Bumper Replacement
Step 1 — Front Bumper
Remove the ten - 11mm screws that are holding the front bumper to the plastic bumper protector with your Phillips head #1
Pull the plastic bumper protector up and off of the bumper
Step 2
Flip the Roomba back over so you are viewing the top
Pull up on the front bumper to remove it
Be careful not to pull to hard because there is wiring attached to the bumper
Remove the two - 7mm screws with your Phillips head #1, holding the wire sensors in place to the front bumper
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 4
iRobot Roomba 655 Pet Series Front Bumper Replacement
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-22 12:49:20 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
iRobot Roomba 655 Pet Series Front Bumper Replacement How to remove the front bumper on your Roomba
Written By: Rhett
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
iRobot Roomba 655 Pet Series Front Bumper Replacement
INTRODUCTION You will be removing the front bumper (this runs into objects and walls) from the Roomba in order to gain access to things like the control center (display) and motherboard.
TOOLS: Phillips #1 Screwdriver (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
iRobot Roomba 655 Pet Series Front Bumper Replacement
Step 1 — Front Bumper
Remove the ten - 11mm screws that are holding the front bumper to the plastic bumper protector with your Phillips head #1
Pull the plastic bumper protector up and off of the bumper
Step 2
Flip the Roomba back over so you are viewing the top
Pull up on the front bumper to remove it
Be careful not to pull to hard because there is wiring attached to the bumper
Remove the two - 7mm screws with your Phillips head #1, holding the wire sensors in place to the front bumper
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 4
iRobot Roomba 655 Pet Series Front Bumper Replacement
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-22 12:49:20 AM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
