Kenmore 110 Series Washing Machine Water Pump Replacement

Kenmore 110 Series Washing Machine Water Pump Replacement

Kenmore 110 Series Washing Machine Water Pump Replacement Replace a faulty water pump on your Kenmore 110 Series Washing Machine.

Written By: Robert Trout

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 4

Kenmore 110 Series Washing Machine Water Pump Replacement

INTRODUCTION Use this guide to replace a faulty water pump on your Kenmore 110 Series Washing Machine.

TOOLS: 1/4" Socket (1) Socket Wrench (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 4

Kenmore 110 Series Washing Machine Water Pump Replacement

Step 1 — Water Pump

 Unplug the washing machine! 

Carefully lay washing machine on its back.

Step 2



Carefully remove both wire harnesses connected to the pump.



Squeeze and pull back hose clamp.



Twist drain hose off of pump.



Using a 1/4" socket wrench, remove the three mounting screws.



Pull the pump out of place.

 Pulling the pump away takes a little force. © iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 4

Kenmore 110 Series Washing Machine Water Pump Replacement

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-16 08:27:24 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 4