Kindle 3 Keyboard Replacement

Report 0 Downloads 74 Views
Kindle 3 Keyboard Replacement

Kindle 3 Keyboard Replacement Written By: James Gauger

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 7

Kindle 3 Keyboard Replacement

INTRODUCTION Use this guide for replacing the keyboard on a Kindle 3. The guide shows how to disassemble the device to replace the damaged keyboard. Before replacing the Kindle 3 keyboard, you need to remove or disconnect the following components: Back cover Fourteen (14 ) silver and eleven (11) gray screws Battery Five (5) cables Motherboard Two (2) plates

TOOLS: Phillips #00 Screwdriver (1) iFixit Opening Tools (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 7

Kindle 3 Keyboard Replacement

Step 1 — Keyboard 

Insert a plastic opening tool into the seam between the back and front of the Kindle 3 (as indicated in the photograph).

 If you have difficulty inserting the plastic opening tool, run the flat edge of the instrument along the seam to find a gap. 

Using the plastic opening tool, lift the back cover of the device.



Remove the back cover.

Step 2



Using a Phillips #00 screwdriver, remove the 14 silver screws (4mm) that secure the components within the housing.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 7

Kindle 3 Keyboard Replacement

Step 3 

Using the screwdriver, remove the 11 gray screws (4mm) that secure the motherboard to the housing.



Remove the battery, starting from the side that was secured by the screws.

Step 4

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 7

Kindle 3 Keyboard Replacement

Step 5



Using the plastic opening tool, carefully lift the ribbon cable to disconnect it from the motherboard.



Latches secure the three remaining ribbon cables to the motherboard.



To disconnect the latched ribbon cable, open the latch and gently slide out the cable.

 The rightmost photograph shows the ribbon cable with an open latch. Step 6 — Remove the 3G card 

© iFixit — CC BY-NC-SA

www.iFixit.com

Insert the plastic opening tool underneath the silver-headed black cable and gently disconnect the cable from the motherboard.

Page 5 of 7

Kindle 3 Keyboard Replacement

Step 7

 The motherboard is connected to the device by a red-and-black twisted pair cable. Do not detach the cable.

 There are 3 spacers. Two of them are where the two screws attaching the battery were. The third is to the bottom right of the silver motherboard unit. Take care not to lose these spacers when moving the motherboard. 

With the cable still attached, flip over the motherboard.

 The silver motherboard unit with a serial number may fall out. If this occurs, slide the unit back into place.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 6 of 7

Kindle 3 Keyboard Replacement

Step 8 

Remove the gray and gold plates from the housing.



Replace the damaged keyboard.

Step 9

 When reassembling the Kindle 3, test the power switch to make sure it moves freely.

 When reassembling the device, do not mix up the gray and silver screw slots.

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-07-01 04:25:11 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 7 of 7