KitchenAid Gas Freestanding and Slide-In Ranges

LAUNDRY PRODUCTS

REFRIGERATION PRODUCTS

3KITCHEN PRODUCTS

K8178519 June 2005

COMMERICAL LAUNDRY

THIS SERVICE POINTER APPLIES TO THE FOLLOWING BRANDS:

3

3

OEM BRANDS

KitchenAid Gas Freestanding and Slide-In Ranges Models: KGRA806P, KGRI801P, KGRK806P, KGSA906P & KGSI901P Whirlpool Slide-In Model GW395LEP

Code dates: All Products built before XS10 CUSTOMER COMPLAINT: Gas oven won’t reignite during cooking cycles.

CAUSE: Misalignment of the gas regulator to the oven burner tube. The 4 Mounting screws of the gas regulator mounting bracket are not inserted correctly causing a misalignment of the regulator onto the burner tube.

CORRECTION: Verify the Bake and Broil ignitor wires are not pinched, cut or disconnected. Adjust gas regulator mounting bracket as shown. ALIGNING THE REGULATOR MOUNTING PLATE There must be a 1/4" gap between the Mounting Plate tabs and the cabinet support bracket. The gap should be similar on both sides.

1/4"

1/4"

REGULATOR MOUNTING PLATE PROPER ALIGNMENT ALL SERVICE POINTERS ONLINE: http://www.servicematters.com/tech_ref/tech_ref_main.htm, SERVICE POINTERS COMMERCIAL LAUNDRY ONLY: www.whirlpoolcorp.com/cltpsc, TECHNICAL INFORMATION, SERVICE POINTERS To receive pointers by email or FAX, or to edit or delete a current email or Fax from our distribution, see http://www.whirlpoolcorp.com/cltpsc/feedback/feedbacksubscribe_all.html, or FAX changes to 269-923-5342.

IMPROPER ALIGNMENT

MORE THAN 1/4"

OR NO GAP

ADJUSTMENT

VERIFY PROPER INSTALLATION OF THESE 4 SCREWS