Kodak S100 EF Flash Replacement
Kodak S100 EF Flash Replacement
Kodak S100 EF Flash Replacement This will instruct the repair of the flash for the Kodak S100 EF.
Written By: Nick
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
Kodak S100 EF Flash Replacement
INTRODUCTION To start, the Front Cover Teardown guide must be used. Later, soldering guides will be used.
TOOLS: Phillips #00 Screwdriver (1) Soldering Workstation (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
Kodak S100 EF Flash Replacement
Step 1 — Front Cover
Have the camera facing up and the flash closest to you.
Unscrew the two 6.2 mm Phillips screws on the top half of the camera.
Step 2
Flip camera to other side-with flash farthest from you.
© iFixit — CC BY-NC-SA
www.iFixit.com
Unscrew top two 6.2mm Phillips screws on this side.
Page 3 of 4
Kodak S100 EF Flash Replacement
Step 3
Turn the camera so the bottom is facing up with the front facing away.
Unscrew the 6.2mm Phillips screw on the top right.
The front cover is now unscrewed and should be lifted up evenly and removed.
Once the front cover is off, desolder the connections at both ends of the flash.
If unfamiliar with soldering, refer to the guide How To Solder and Desolder Connections
Step 4 — Flash
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-23 02:13:49 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
Kodak S100 EF Flash Replacement This will instruct the repair of the flash for the Kodak S100 EF.
Written By: Nick
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 4
Kodak S100 EF Flash Replacement
INTRODUCTION To start, the Front Cover Teardown guide must be used. Later, soldering guides will be used.
TOOLS: Phillips #00 Screwdriver (1) Soldering Workstation (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 4
Kodak S100 EF Flash Replacement
Step 1 — Front Cover
Have the camera facing up and the flash closest to you.
Unscrew the two 6.2 mm Phillips screws on the top half of the camera.
Step 2
Flip camera to other side-with flash farthest from you.
© iFixit — CC BY-NC-SA
www.iFixit.com
Unscrew top two 6.2mm Phillips screws on this side.
Page 3 of 4
Kodak S100 EF Flash Replacement
Step 3
Turn the camera so the bottom is facing up with the front facing away.
Unscrew the 6.2mm Phillips screw on the top right.
The front cover is now unscrewed and should be lifted up evenly and removed.
Once the front cover is off, desolder the connections at both ends of the flash.
If unfamiliar with soldering, refer to the guide How To Solder and Desolder Connections
Step 4 — Flash
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-23 02:13:49 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 4
