lunch mate® kit cardboard ornament
ENT M A N R O RD A O B D R A KIT C ® E T A M H LUNC
LUNCH MATE® KIT CARDBOARD ORNAMENT Make a white winter a little greener with this project!
MATERIALS
TOOLS
• 1 Lunch Mate Cardboard Package • Ribbon
• • • • •
Scissors Ruler Pencil or pen Hole punch 2 Brass fasteners
Instructions: STEP 1 Open up the cardboard package and flatten it out.
STEP 2 Measure and cut out ten 10 cm long strips with a width of 1 cm. Cut a 15 cm length of ribbon.
STEP 3 Punch a hole in the left and right ends of each strip, about 5 mm away from the end. Punch a hole in the center of your ribbon.
STEP 4 Use your pen or pencil to hold down the cardboard strips and pull the strip up to curl it.
Design Tip :
Using the backside of the cardboard packaging allows you to draw and customize your ornament!
STEP 5 Put your brass fastener through one end of each strip and bend it closed.
STEP 6 Use another brass fastener to go through the hole in the ribbon and then the remaining holes.
STEP 7 Tie off your ribbon, spread out the strips, and hang from the best tree you can find.
Sign up for the TerraCycle Recycling Programs at www.terracycle.ca TerraCycle® and the TerraCycle Logo® are property of TerraCycle, Inc. used under license. ©2017
ÉCOR! D Y A D I L R HO U O Y H T I ALL W B A E V A H
LUNCH MATE® KIT CARDBOARD ORNAMENT Make a white winter a little greener with this project!
MATERIALS
TOOLS
• 1 Lunch Mate Cardboard Package • Ribbon
• • • • •
Scissors Ruler Pencil or pen Hole punch 2 Brass fasteners
Instructions: STEP 1 Open up the cardboard package and flatten it out.
STEP 2 Measure and cut out ten 10 cm long strips with a width of 1 cm. Cut a 15 cm length of ribbon.
STEP 3 Punch a hole in the left and right ends of each strip, about 5 mm away from the end. Punch a hole in the center of your ribbon.
STEP 4 Use your pen or pencil to hold down the cardboard strips and pull the strip up to curl it.
Design Tip :
Using the backside of the cardboard packaging allows you to draw and customize your ornament!
STEP 5 Put your brass fastener through one end of each strip and bend it closed.
STEP 6 Use another brass fastener to go through the hole in the ribbon and then the remaining holes.
STEP 7 Tie off your ribbon, spread out the strips, and hang from the best tree you can find.
Sign up for the TerraCycle Recycling Programs at www.terracycle.ca TerraCycle® and the TerraCycle Logo® are property of TerraCycle, Inc. used under license. ©2017
ÉCOR! D Y A D I L R HO U O Y H T I ALL W B A E V A H
