METAFLEX Play-Insitu In-situ EPDM Rubber Flooring System PRODUCT DATA
PRODUCT DESCRIPTION METAFLEX Play-Insitu is a laid in-situ, seamless, resilient, water permeable flooring system. The 2-layer system consist of a black rubber granules base and coloured EPDM granules top layer, bonded together by solvent-free single component, MDI based, moisture curing polyurethane binders. Provides a decorative, shock-absorbent, functional flooring system for children playgrounds, fitness stations, multipurpose sports and recreational facilities.
ADVANTAGES
Non-slip Resilient & shock absorbent Wide selection of attractive colours Economical and easy maintenance
TYPICAL USES
Fitness stations Daycare centres Children playgrounds Footpath and walkways Golf courses & driving ranges
TECHNICAL INFORMATIONS Base Layer
:
1-4mm black granules (made from recycled tyre)
Top Layer
:
1-4 mm coloured EPDM granules
Binder
:
Solvent-free, single component, MDI based, moisture curing polyurethane
Thickness
:
50mm, 75mm Other requested thickness
Curing
:
Minimum 24 hours
Shelf Life (binder)
:
12 months
COLOUR RANGE Standard colours
:
Red, Light Blue, Dark Blue, Mid Green, Dark Green, Beige, Earth Yellow, Bright Yellow, Orange, Black. Mixing of 2 or more colours to create a wide varieties of colour combinations.
TOP LAYER Mix the EPDM granules and polyurethane binder in a force action mixer until a homogeneous mix is obtained. Place the mixed materials onto the substrate and spread the materials to the required thickness. Trowel smooth using a steel trowel. Allow to cure for minimum 24 hours before allowing any foot traffic.
LIMITATIONS
SURFACE PREPARATION All substrate should be clean, dry and free from oil, grease and other contaminants. Concrete / cementitious substrates must be at lease 7 days old and free from laitance, debonding agent etc. Clean, vacuum or wash to remove contaminants, loose materials, sand and mud etc. and allow substrate to dry.
BASE LAYER Mix the black granules and polyurethane binder in a force action mixer until a homogeneous mix is obtained. Place the mixed materials onto the substrate and spread the materials to the required thickness. Trowel smooth using a steel trowel and allow to cure.
Substrate must be structurally sound, with proper gradient and/or drainage to avoid stagnant and ponding water. The flooring system is intended for foot traffic only. Occasional vehicular traffic is acceptable but not intended for continuous vehicular traffic movement.
HEALTH AND SAFETY Normal industrial standards and practices for housekeeping, cleanliness and personal protection should be observed. Remove stains and splashes with soap and water. If product comes into contact with eyes, rinse copiously with water and seek medical attention in case of continued irritation. 08/2012
All information contained herein is correct to the best of our knowledge. However, we cannot accept any liability either directly or indirectly arising from the use of the products. If the customer has any particular requirements, it should make them know in writing to Coating & Lining and obtain further advice accordingly.
Sports & Recreational Surfaces Industrial Flooring & Coatings Decorative Wall & Floor Finishes
COATING & LINING TECHNOLOGIES PTE LTD 1 Bukit Batok Crescent, #08-39 Wcega Plaza, Singapore 658064 Tel: +65-62661113 Fax: +65-62661110
www.coating.com.sg
[email protected]