PlayStation Controller Port Replacement

PlayStation Controller Port Replacement

PlayStation Controller Port Replacement Written By: JakeDeschamps

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 5

PlayStation Controller Port Replacement

INTRODUCTION This will guide you through the replacement of your controller port.

TOOLS: Phillips #1 Screwdriver (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 5

PlayStation Controller Port Replacement

Step 1 — PlayStation Case Disassembly 

Remove the parallel port cover on the back of the PlayStation.



Flip over the PlayStation and remove the six screws from the bottom.

Step 2

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 5

PlayStation Controller Port Replacement

Step 3 

Turn the PlayStation upright. Remove the cover by lifting it up.

Step 4 — Controller Port



Remove the two screws securing the controller port to the case.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 5

PlayStation Controller Port Replacement

Step 5 

Gently disconnect the ribbon cable from the logic board. This is done by pulling on the blue area of the cable near the connector.



Remove and replace the controller port.

Step 6

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-17 07:28:25 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 5 of 5