Plugging in Shure SM58 XLR Cable

Plugging in Shure SM58 XLR Cable

Plugging in Shure SM58 XLR Cable This guide will show you how to install (or plug in) the XLR cable to the microphone.

Written By: nat coll

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 4

Plugging in Shure SM58 XLR Cable

INTRODUCTION The function of a XLR cable is to carry a balanced audio signal. It connects in the bottom of the microphone to the XLR microphone connector.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 4

Plugging in Shure SM58 XLR Cable

Step 1 — XLR Cable Plug In 

Make sure you have a proper three pin XLR cable.



Grab the female end of the cable (plug with three holes).



Line up the pins in the end of the microphone (microphone connecter) with the holes in the XLR cable.

Step 2

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 4

Plugging in Shure SM58 XLR Cable

Step 3 

Once the pins are aligned, push the cable into the bottom end of the microphone. You should hear a click.

To disconnect the cable from the microphone, follow the instructions in reverse. This document was last generated on 2017-06-24 11:16:04 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 4