Polaroid One-Step 600 Lens Replacement
Polaroid One-Step 600 Lens Replacement
Polaroid One-Step 600 Lens Replacement Written By: Doug Jimenez
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 7
Polaroid One-Step 600 Lens Replacement
INTRODUCTION This guide will show you how to replace the lens on your Polaroid camera if it breaks or gets scratched. However, you should be careful with your Polaroid, as the plastic is very fragile.
TOOLS: Spudger (1) Tweezers (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 7
Polaroid One-Step 600 Lens Replacement
Step 1 — Lens
Open the flash compartment of the camera so it makes a 30 degree angle with the horizontal.
Step 2
Separate the flash section of the camera from the main body by unhooking the sides with the spudger.
BE CAREFUL NOT TO YANK THE TWO SECTIONS APART BECAUSE THE BAND WIRE STILL ATTACHES THEM!
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 7
Polaroid One-Step 600 Lens Replacement
Step 3
Fully open the battery/ cartridge compartment by sliding the side tab toward you.
Step 4
Insert spudger in between face of camera and sides where the four tabs are located.
BE CAREFUL! The button that is pressed to take a picture may pop out of the camera at this step.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 7
Polaroid One-Step 600 Lens Replacement
Step 5
Once tabs are released, pull face of camera straight out.
Step 6
© iFixit — CC BY-NC-SA
www.iFixit.com
Use spudger to twist the notch on the lens into the opening to remove it.
Page 5 of 7
Polaroid One-Step 600 Lens Replacement
Step 7
Carefully use spudger to release lens, then lift lens out of camera with fingers.
CAUTION: LENS MAY POP OUT OF CAMERA; REMOVE CAREFULLY. Step 8
Clean old lens with a microfiber cloth or get a new lens to put back into the camera.
To reassemble your device, follow these instructions in reverse order. © iFixit — CC BY-NC-SA
www.iFixit.com
Page 6 of 7
Polaroid One-Step 600 Lens Replacement This document was last generated on 2017-06-24 04:36:17 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 7 of 7
Polaroid One-Step 600 Lens Replacement Written By: Doug Jimenez
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 7
Polaroid One-Step 600 Lens Replacement
INTRODUCTION This guide will show you how to replace the lens on your Polaroid camera if it breaks or gets scratched. However, you should be careful with your Polaroid, as the plastic is very fragile.
TOOLS: Spudger (1) Tweezers (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 7
Polaroid One-Step 600 Lens Replacement
Step 1 — Lens
Open the flash compartment of the camera so it makes a 30 degree angle with the horizontal.
Step 2
Separate the flash section of the camera from the main body by unhooking the sides with the spudger.
BE CAREFUL NOT TO YANK THE TWO SECTIONS APART BECAUSE THE BAND WIRE STILL ATTACHES THEM!
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 7
Polaroid One-Step 600 Lens Replacement
Step 3
Fully open the battery/ cartridge compartment by sliding the side tab toward you.
Step 4
Insert spudger in between face of camera and sides where the four tabs are located.
BE CAREFUL! The button that is pressed to take a picture may pop out of the camera at this step.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 7
Polaroid One-Step 600 Lens Replacement
Step 5
Once tabs are released, pull face of camera straight out.
Step 6
© iFixit — CC BY-NC-SA
www.iFixit.com
Use spudger to twist the notch on the lens into the opening to remove it.
Page 5 of 7
Polaroid One-Step 600 Lens Replacement
Step 7
Carefully use spudger to release lens, then lift lens out of camera with fingers.
CAUTION: LENS MAY POP OUT OF CAMERA; REMOVE CAREFULLY. Step 8
Clean old lens with a microfiber cloth or get a new lens to put back into the camera.
To reassemble your device, follow these instructions in reverse order. © iFixit — CC BY-NC-SA
www.iFixit.com
Page 6 of 7
Polaroid One-Step 600 Lens Replacement This document was last generated on 2017-06-24 04:36:17 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 7 of 7
