Power Mac G5 CD-ROM Drive Replacement

Report 2 Downloads 122 Views
Power Mac G5 CD-ROM Drive Replacement

Power Mac G5 CD-ROM Drive Replacement Replace the CD-ROM drive.

Written By: Jessica Chaidez

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 8

Power Mac G5 CD-ROM Drive Replacement

INTRODUCTION Use this guide to replace the CD-ROM drive in your Power Mac G5.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 8

Power Mac G5 CD-ROM Drive Replacement

Step 1 — Side Panel

 To avoid electrocution, shut down the computer. Do not open the computer or attempt to install any items inside it while the computer is on.

 To avoid being burned, wait at least 10 minutes to allow the computer's internal components to cool.

Step 2 

© iFixit — CC BY-NC-SA

www.iFixit.com

Remove all the cables, including the power cables before opening the unit.

Page 3 of 8

Power Mac G5 CD-ROM Drive Replacement

Step 3



Lift the tab to unlock the side panel.

 The panel should fall out. If the panel does not fall out by itself pull a little from the edges. Step 4



Remove the air deflector (the clear plastic cover) by pulling on the handle.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 8

Power Mac G5 CD-ROM Drive Replacement

Step 5 — CD-ROM Drive 

Locate the CD-ROM Drive on the top left corner of desktop.

Step 6



Pull and rotate latches to the left.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 5 of 8

Power Mac G5 CD-ROM Drive Replacement

Step 7 

© iFixit — CC BY-NC-SA

www.iFixit.com

Wiggle and pull out the CD Drive.

Page 6 of 8

Power Mac G5 CD-ROM Drive Replacement

Step 8



Detach the first cable from the CD-ROM drive.



Detach the second cable from the CD-ROM drive.

 On some models, the IDE cable is stuck to the top of the CD-ROM with foam tape. It is easier to unplug the IDE connector from the motherboard, and de-route the IDE cable as you remove the drive.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 7 of 8

Power Mac G5 CD-ROM Drive Replacement

Step 9 

After the CD-ROM drive is removed, the area should look like this.

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-17 06:39:31 AM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 8 of 8