PowerBook G4 Titanium Onyx Lower Case Replacement AWS

PowerBook G4 Titanium Onyx Lower Case Replacement

PowerBook G4 Titanium Onyx Lower Case Replacement Written By: iRobot

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 4

PowerBook G4 Titanium Onyx Lower Case Replacement

INTRODUCTION The bottom case slides off easily after removing a few T8 Torx screws.

TOOLS:

PARTS:

T8 Torx Screwdriver (1)

G4 Titanium Onyx Lower Case (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 4

PowerBook G4 Titanium Onyx Lower Case Replacement

Step 1 — Lower Case



Turn the G4 over.



Remove the eight T8 Torx screws from the lower case.

Step 2 

Using your thumbs, slide the lower case away from you.

 The lower case may stick in the front on a tab just above the center of the DVD drive. Be careful as you work the case off, or you may break the thin strip of plastic just above the drive. 

© iFixit — CC BY-NC-SA

www.iFixit.com

Lift the lower case off.

Page 3 of 4

PowerBook G4 Titanium Onyx Lower Case Replacement

Step 3 

Your laptop should look approximately like this.

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-20 07:48:46 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 4