PROVEN PERFORMANCE
PROVEN PERFORMANCE
faCt shEEt
roVral® flo is a Canola fUngiCiDE that Controls sClErotinia anD sUPPrEssEs altErnaria • Rovral fungicide has shown an average yield increase of 115% versus untreated checks • It is formulated as a fl owable and does not require surfactant • Rovral comes in an 8.4L jug; 2 per case. 1 case will treat 20 acres at the standard rate • Registered for 20-50% bloom, IDEAL is 20-30% bloom (4-8 days after the start of fl owering) • Spray when the fi eld is at its most yellow color, NO PETAL drop; NO POD formation • Weather Conditions – No real ideal conditions are required, best to apply when disease timing is correct • This product should not be applied under conditions where run-off is likely to occur • Insecticide tank-mixes – Recommend a jar test for compatibility
fast faCts
CoMPlEtE ratEs
• Group 2 Fungicide
¾ rate
- Active Ingredient = Iprodione
for less dense canopies or lower disease pressure
- Mode of Action = contact & locally systemic
.63L/ac – 12.5 acres/jug 20-50% bloom stage
- Apply at 20-30% bloom - Rate = 0.84L/ac
standard rate
- Water Volume Ground = 10 gal/ac Air = 5 gal/ac
0.84 L/ac – 10 acres/jug
- Coverage is crucial for maximum protection
1st application 20% bloom & 2nd application 50%
- Rainfastness = 1 hour
0.42 L/ac followed by 0.42 L/ac (½ rate : ½ rate)
split application
0.63 L/ac followed by 0.42 L/ac (½ rate : ½ rate)
F100-026890-1-Canada_Rovral-FactSheet_Reprint.indd 1
9/20/12 3:41 PM
FACT SHEET
What to look for in staging
Why is 20-30% Bloom “ideal”?
20% Bloom
Think of the bloom period as a bell curve. If we apply a fungicide at 20-30%, and
- Earliest time to consider application
it provides 10-14 days control, we protect the largest area under the bell curve.
- Usually 4-6 days after the start of flowering - Approximately 15 flowers open on main stem
50% 30%
30% Bloom
70%
20%
- Ideal time for application
20%
- Usually 6-8 days after the start of flowering - Approximately 18-20 flowers open on main stem
Start
50% Bloom
Finish
- Correct time for 2nd application in a split application program - Usually 10-14 days after the start of flowering - Some petals have dropped and pod formation has started Restrictions
TIMELINE Too early: we leave ourselves susceptible to “late infection”
- Re-entry is 48 hours - Allow four hours before starting irrigation if it is used
Too late: we leave ourselves susceptible to “early infection”
- Water pH greater than 8.0 may cause efficacy loss - Do not apply to bodies of water
Learn More About Rovral Fungicide For more information visit www.FMCcrop.com.
Always read and follow label directions. FMC and Rovral are trademarks and Investing in farming’s future is a service mark of FMC Corporation. ©2012 FMC Corporation. All rights reserved. F100-26890 9/12
F100-026890-1-Canada_Rovral-FactSheet_Reprint.indd 2
9/20/12 3:41 PM
faCt shEEt
roVral® flo is a Canola fUngiCiDE that Controls sClErotinia anD sUPPrEssEs altErnaria • Rovral fungicide has shown an average yield increase of 115% versus untreated checks • It is formulated as a fl owable and does not require surfactant • Rovral comes in an 8.4L jug; 2 per case. 1 case will treat 20 acres at the standard rate • Registered for 20-50% bloom, IDEAL is 20-30% bloom (4-8 days after the start of fl owering) • Spray when the fi eld is at its most yellow color, NO PETAL drop; NO POD formation • Weather Conditions – No real ideal conditions are required, best to apply when disease timing is correct • This product should not be applied under conditions where run-off is likely to occur • Insecticide tank-mixes – Recommend a jar test for compatibility
fast faCts
CoMPlEtE ratEs
• Group 2 Fungicide
¾ rate
- Active Ingredient = Iprodione
for less dense canopies or lower disease pressure
- Mode of Action = contact & locally systemic
.63L/ac – 12.5 acres/jug 20-50% bloom stage
- Apply at 20-30% bloom - Rate = 0.84L/ac
standard rate
- Water Volume Ground = 10 gal/ac Air = 5 gal/ac
0.84 L/ac – 10 acres/jug
- Coverage is crucial for maximum protection
1st application 20% bloom & 2nd application 50%
- Rainfastness = 1 hour
0.42 L/ac followed by 0.42 L/ac (½ rate : ½ rate)
split application
0.63 L/ac followed by 0.42 L/ac (½ rate : ½ rate)
F100-026890-1-Canada_Rovral-FactSheet_Reprint.indd 1
9/20/12 3:41 PM
FACT SHEET
What to look for in staging
Why is 20-30% Bloom “ideal”?
20% Bloom
Think of the bloom period as a bell curve. If we apply a fungicide at 20-30%, and
- Earliest time to consider application
it provides 10-14 days control, we protect the largest area under the bell curve.
- Usually 4-6 days after the start of flowering - Approximately 15 flowers open on main stem
50% 30%
30% Bloom
70%
20%
- Ideal time for application
20%
- Usually 6-8 days after the start of flowering - Approximately 18-20 flowers open on main stem
Start
50% Bloom
Finish
- Correct time for 2nd application in a split application program - Usually 10-14 days after the start of flowering - Some petals have dropped and pod formation has started Restrictions
TIMELINE Too early: we leave ourselves susceptible to “late infection”
- Re-entry is 48 hours - Allow four hours before starting irrigation if it is used
Too late: we leave ourselves susceptible to “early infection”
- Water pH greater than 8.0 may cause efficacy loss - Do not apply to bodies of water
Learn More About Rovral Fungicide For more information visit www.FMCcrop.com.
Always read and follow label directions. FMC and Rovral are trademarks and Investing in farming’s future is a service mark of FMC Corporation. ©2012 FMC Corporation. All rights reserved. F100-26890 9/12
F100-026890-1-Canada_Rovral-FactSheet_Reprint.indd 2
9/20/12 3:41 PM
