Removing iMac G4 15" 700 MHz EMC 1873 Outer Base Plate

Removing iMac G4 15" 700 MHz EMC 1873 Outer Base Plate

Removing iMac G4 15" 700 MHz EMC 1873 Outer Base Plate We will be removing the metal outer Base plate.

Written By: Elliot Freerks

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 4

Removing iMac G4 15" 700 MHz EMC 1873 Outer Base Plate

INTRODUCTION This is the initial step in any repair guide. It is simple, quick, and will only take a few minutes.

TOOLS: Phillips #00 Screwdriver (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 4

Removing iMac G4 15" 700 MHz EMC 1873 Outer Base Plate

Step 1 — Outer Base Plate

 Place the computer monitor face down on a safe, harmless surface. 

Using a Phillips #00 screw driver, remove the four 6.86 mm screws from the metal plate.

Step 2 

Remove the metal plate from bottom of the iMac G4.

 The four screws do not completely separate from the metal plate.

To reassemble your device, follow these instructions in reverse order. © iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 4

Removing iMac G4 15" 700 MHz EMC 1873 Outer Base Plate This document was last generated on 2017-06-21 11:12:01 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 4