Rittal – North American Industrial Buyer's Guide

Rittal – North American Industrial Buyer’s Guide

Cable Management Cable entry grommets

In conjunction with the cable entry plate, simple and fast sealing of cables inserted in the base area of enclosures. Material: Body: Polypropylene Cover: Thermoplastic elastomer

Cables per grommet

Max. Ø inches (mm)

PU

Part No.

8

0.5 (13)

25

4316.000

3

0.8 (21)

25

4317.000

1

1.9 (47)

25

4318.000

Protection ratings: IP 55 subject to correct mounting

Connector grommets

Suitable for cable diameters from 8 to 36 mm. Material: Outer cover: Polypropylene covered with thermoplastic elastomer Seal: Cellular rubber

PU

Part No.

10

4311.000

Protection Ratings: IP 55 subject to correct mounting

Section for cable entry, center

For TS, CM, TP For top-mounting on gland plates. A superior alternative to the foam rubber cable clamp strip, thanks to: • Easier mounting • Full-surface support • High level of sealing of cables inserted into the enclosure Material: Extruded aluminium section, seal PU foam, cross-section: 1 x 1" (30 x 25 mm) Protection Ratings: IP 55 subject to correct mounting

Section for cable entry, rear

For TS, CM, TP Unlike the section for cable entry, center, the rear section is mounted directly onto the base opening. In this way, when installing the mounting panel in the rear most position (TS) or with CM, the cables may be routed directly on a cable clamping rail with no large radii. In conjunction with the cable clamp rail, optimum adjustment between the cable entry and mounting panel can be achieved. Material: Extruded aluminium section, seal PU foam, cross-section: 1 x 1" (30 x 25 mm)

For enclosure width inches (mm)

PU

Part No.

24 (600)

1 set

8802.060

32 (800)

1 set

8802.080

39 (1000)

2 sets

8802.100

47 (1200)

2 sets

8802.120

63 (1600)

2 sets

8802.160

Note: One set is sufficient for one base opening up to an enclosure width of 31" (800 mm). From an enclosure width of 39" (1000 mm), two base openings are provided. Two sets per enclosure may be fitted. For enclosure width inches (mm)

PU

Part No.

24 (600)

1 set

8802.065

32 (800)

1 set

8802.085

39 (1000)

2 sets

8802.105

47 (1200)

2 sets

8802.125

63 (1600)

2 sets

8802.165

Note: One set is sufficient for one base opening up to an enclosure width of 31" (800 mm). From an enclosure width of 39" (1000 mm), two base openings are provided. Two sets per enclosure may be fitted.

Protection Ratings: IP 55 subject to correct mounting

Industrial Buyers Guide

Inch and pound measurements are rounded to the nearest whole number

347