Samsung Galaxy S6/S7 Edge Screw identification

Samsung Galaxy S6/S7 Edge Screw identification

Samsung Galaxy S6/S7 Edge Screw identification Galaxy S6/S7 Edge - Dont Mix Up Screws!!!

Written By: Nick Kane

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 4

Samsung Galaxy S6/S7 Edge Screw identification

INTRODUCTION Samsung has used the same screws in all mobile phone from the S3 - S5 models including the minis. The S6 series brought about new screws and if mixed up screws in too far and causes damage.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 4

Samsung Galaxy S6/S7 Edge Screw identification

Step 1 — Samsung Galaxy S6/S7 Edge Screw identification 

3.2mm S6 / S6 Edge & S7 series screws are 3.2mm.



S3, S4, S5 screws are 3.8mm, an extra 0.6mm over the S6 and S7 series.

Step 2

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 4

Samsung Galaxy S6/S7 Edge Screw identification

Step 3 

Using 3.8mm screw around edges S6 / S7 Edge will cause damage to the LCD as per photo. Only ever use 3.2mm phillips head screws on S6 and S7 screen replacements.

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-17 07:20:01 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 4