Sony Ericsson TM506 Back Case Replacement

Sony Ericsson TM506 Back Case Replacement

Sony Ericsson TM506 Back Case Replacement Installation guide for the back case.

Written By: Minnal

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 5

Sony Ericsson TM506 Back Case Replacement

INTRODUCTION This guide provides instruction for installing a back case for the Sony Ericsson TM506 cell phone.

TOOLS: iFixit Opening Tools (1) T6 Torx Screwdriver (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 5

Sony Ericsson TM506 Back Case Replacement

Step 1 — Battery Cover



Firmly hold the phone between your fingers with your thumb on the battery cover.



Push down with your thumb until the battery cover comes off.

Step 2 — Back Case



Unscrew the bottom two 5.4mm screws with a Torx T6 screwdriver.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 5

Sony Ericsson TM506 Back Case Replacement

Step 3



Remove the two rubber casings for the top two screws with a plastic opening tool.

Step 4 

© iFixit — CC BY-NC-SA

www.iFixit.com

Unscrew these two 5.4mm screws with a Torx T6 screwdriver.

Page 4 of 5

Sony Ericsson TM506 Back Case Replacement

Step 5



There are eight snap hooks located around the outer case. Carefully snap these to remove the outer case.

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-24 01:26:55 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 5 of 5