Sony SRS-X55 I/O Board Replacement

Sony SRS-X55 I/O Board Replacement

Sony SRS-X55 I/O Board Replacement Replace the I/O board on your Sony SRS-X55 speaker.

Written By: Bradley Conner

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 5

Sony SRS-X55 I/O Board Replacement

INTRODUCTION If your Sony SRS-X55 speaker won't play sound from the auxiliary jack, replacing the I/O board may resolve the problem.

TOOLS: Phillips #1 Screwdriver (1) Spudger (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 5

Sony SRS-X55 I/O Board Replacement

Step 1 — Battery



Remove the six screw covers with a spudger.



Remove the six 11 mm Phillips screws from the bottom panel.



Remove the bottom panel of the speaker.

Step 2

© iFixit — CC BY-NC-SA

www.iFixit.com



Disconnect the battery cable from the motherboard.



Remove the battery.

Page 3 of 5

Sony SRS-X55 I/O Board Replacement

Step 3 — I/O Board



Remove the two Phillips screws from the I/O board.



Remove the front panel to the speaker by pushing on the two tabs in the corners.

Step 4 

Disconnect the ribbon cable from the I/O board.



Carefully remove the I/O board from the speaker.

To reassemble your device, follow these instructions in reverse order. © iFixit — CC BY-NC-SA

www.iFixit.com

Page 4 of 5

Sony SRS-X55 I/O Board Replacement This document was last generated on 2017-07-08 04:04:16 AM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 5 of 5