THE MAKERBOT® FILAMENT CASE

THE MAKERBOT ® FILAMENT CASE The MakerBot Filament Case allows for convenient storage and use of MakerBot XL and XXL spools with the MakerBot® Replicator® Z18 3D Printer.

PARTS LIST

2

1 MakerBot Filament Case

Filament guide tubes

2 Guide tube adapters

Note: MakerBot XXL filament spool ships separately.

IMPORTANT SAFETY INFORMATION Carefully read all instructions before use. Keep these instructions for future reference. Caution: When using the Filament Case in conjunction with the MakerBot Cart for the MakerBot Replicator Z18, avoid leaving the Filament Case empty and open on the cart shelf. The case could fall and break.

ASSEMBLY INSTRUCTIONS 1. INSERT THE GUIDE TUBE ADAPTERS INTO THE GROMMETS ON THE FILAMENT CASE.

2. OPEN THE CASE BY DEPRESSING THE LATCH.

3. REMOVE THE SPOOL AXLE FROM THE MAKERBOT FILAMENT CASE AND LOAD A FILAMENT SPOOL.

4. INSERT A FILAMENT GUIDE TUBE INTO ONE OF THE GUIDE TUBE ADAPTERS.

Note: Ensure filament winds over the top of the spool.

5. ROUTE FILAMENT THROUGH THE GUIDE TUBE.

6. INSERT THE LOOSE END OF THE GUIDE TUBE INTO THE PORT AT THE TOP LEFT SIDE OF THE MAKERBOT REPLICATOR Z18.

www.makerbot.com