traction pads
I’M NOT A STICKER, DON’T TREAT ME LIKE ONE!
TRACTION PADS Installation Instructions General Info & Recommendations. APPLY TO A CLEAN, DRY, WARM (ROOM TEMP.) SNOWBOARD/SKI AT LEAST 30 MINUTES BEFORE USE. The 3M adhesive builds strength over 72 hours, we suggest applying the product 24 hours before use. The adhesive is pressure sensitive so the more pressure you apply, the better it will stick. 1. Remove pad from packaging Cut Plastic wrap along edge of pad and carefully remove pad from packaging. 2. Clean the Surface. (Extremely Important) Be sure to use a cleaner that leaves no residue and is strong enough to remove all waxes, silicones, and adhesive removers that may have been used prior. Clean the area multiple times if necessary. Acceptable cleaners = brake cleaner, carb cleaner, acetone, hepthane, alcohol, or dish soap & warm water. note: It is your responsibility to test and choose the strongest cleaner that will not adversly affect the surface finish. 3. Application. 3a. Peel adhesive liner off of one corner. 3b. Line up pad where you want it to go and stick down the corner. 3c. Apply onto surface from one edge to the other while carefully pushing air out. 3d. Stomp on it. The more pressure the better. 4. Traction in Action - Go ride!
Inc.
Web: www.stompgrip.com E-mail: [email protected] 15431 Chemical Ln. Huntington Beach California 92649 Toll Free: 888-612-5240 Phone: 714-894-9388 Fax: 714-894-4648
TRACTION PADS Installation Instructions General Info & Recommendations. APPLY TO A CLEAN, DRY, WARM (ROOM TEMP.) SNOWBOARD/SKI AT LEAST 30 MINUTES BEFORE USE. The 3M adhesive builds strength over 72 hours, we suggest applying the product 24 hours before use. The adhesive is pressure sensitive so the more pressure you apply, the better it will stick. 1. Remove pad from packaging Cut Plastic wrap along edge of pad and carefully remove pad from packaging. 2. Clean the Surface. (Extremely Important) Be sure to use a cleaner that leaves no residue and is strong enough to remove all waxes, silicones, and adhesive removers that may have been used prior. Clean the area multiple times if necessary. Acceptable cleaners = brake cleaner, carb cleaner, acetone, hepthane, alcohol, or dish soap & warm water. note: It is your responsibility to test and choose the strongest cleaner that will not adversly affect the surface finish. 3. Application. 3a. Peel adhesive liner off of one corner. 3b. Line up pad where you want it to go and stick down the corner. 3c. Apply onto surface from one edge to the other while carefully pushing air out. 3d. Stomp on it. The more pressure the better. 4. Traction in Action - Go ride!
Inc.
Web: www.stompgrip.com E-mail: [email protected] 15431 Chemical Ln. Huntington Beach California 92649 Toll Free: 888-612-5240 Phone: 714-894-9388 Fax: 714-894-4648
