VTech CS6719-2 Speaker Replacement
VTech CS6719-2 Speaker Replacement
VTech CS6719-2 Speaker Replacement This is a guide for replacing the speaker unit.
Written By: Benjamin Field
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 8
VTech CS6719-2 Speaker Replacement
INTRODUCTION During this guide, the back of the phone will need to be taken off to access the speaker and wires. You will need to use the tweezers to remove the metal “U” shaped clip holding the speaker to the back cover.
TOOLS: flat head tweezer (1) Soldering Station (1) Solder (1) Phillips #0 Screwdriver (1) Heavy-Duty Spudger (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 8
VTech CS6719-2 Speaker Replacement
Step 1 — Battery
Push down on the battery cover in the direction of the arrow located on the back of the phone.
Step 2
© iFixit — CC BY-NC-SA
www.iFixit.com
Pull the battery cover off of the back of the phone
Page 3 of 8
VTech CS6719-2 Speaker Replacement
Step 3
Unplug the battery input cable.
Lift the battery out of the back of the phone.
Step 4
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 8
VTech CS6719-2 Speaker Replacement
Step 5 — Circuit Board
Remove the two screws ( 9mm) on the back side with a Phillips #0 screwdriver.
Step 6
© iFixit — CC BY-NC-SA
www.iFixit.com
Use the plastic opening tool and spudger to pry the back side of the phone off.
Page 5 of 8
VTech CS6719-2 Speaker Replacement
Step 7
Remove the two screws(9mm) located inside the back cover at the top.
Step 8 — Speaker
Locate the metal shaped U clip holding the speaker on. Pull up and towards the top of the phone with the flat head tweezers.
The clip is loose, it could fall out.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 6 of 8
VTech CS6719-2 Speaker Replacement
Step 9
Lift speaker out.
Heat up solder joint on the circuit board where the speaker wires are connected.
Step 10
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 7 of 8
VTech CS6719-2 Speaker Replacement
Step 11
Refer to How To Solder and Desolder Connections How To Solder and Desolder Connections
Note: Ensure the old solder joint is removed.
Caution: Soldering iron and joint will become very ho
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-21 10:38:18 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 8 of 8
VTech CS6719-2 Speaker Replacement This is a guide for replacing the speaker unit.
Written By: Benjamin Field
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 8
VTech CS6719-2 Speaker Replacement
INTRODUCTION During this guide, the back of the phone will need to be taken off to access the speaker and wires. You will need to use the tweezers to remove the metal “U” shaped clip holding the speaker to the back cover.
TOOLS: flat head tweezer (1) Soldering Station (1) Solder (1) Phillips #0 Screwdriver (1) Heavy-Duty Spudger (1)
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 8
VTech CS6719-2 Speaker Replacement
Step 1 — Battery
Push down on the battery cover in the direction of the arrow located on the back of the phone.
Step 2
© iFixit — CC BY-NC-SA
www.iFixit.com
Pull the battery cover off of the back of the phone
Page 3 of 8
VTech CS6719-2 Speaker Replacement
Step 3
Unplug the battery input cable.
Lift the battery out of the back of the phone.
Step 4
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 8
VTech CS6719-2 Speaker Replacement
Step 5 — Circuit Board
Remove the two screws ( 9mm) on the back side with a Phillips #0 screwdriver.
Step 6
© iFixit — CC BY-NC-SA
www.iFixit.com
Use the plastic opening tool and spudger to pry the back side of the phone off.
Page 5 of 8
VTech CS6719-2 Speaker Replacement
Step 7
Remove the two screws(9mm) located inside the back cover at the top.
Step 8 — Speaker
Locate the metal shaped U clip holding the speaker on. Pull up and towards the top of the phone with the flat head tweezers.
The clip is loose, it could fall out.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 6 of 8
VTech CS6719-2 Speaker Replacement
Step 9
Lift speaker out.
Heat up solder joint on the circuit board where the speaker wires are connected.
Step 10
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 7 of 8
VTech CS6719-2 Speaker Replacement
Step 11
Refer to How To Solder and Desolder Connections How To Solder and Desolder Connections
Note: Ensure the old solder joint is removed.
Caution: Soldering iron and joint will become very ho
To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-21 10:38:18 PM.
© iFixit — CC BY-NC-SA
www.iFixit.com
Page 8 of 8
