Canon EOS Rebel G Back Panel Latch Replacement

Canon EOS Rebel G Back Panel Latch Replacement

Canon EOS Rebel G Back Panel Latch Replacement How to replace faulty back panel latch.

Written By: Zach

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 1 of 5

Canon EOS Rebel G Back Panel Latch Replacement

INTRODUCTION This guide teaches how to to install the back panel latch on your camera.

TOOLS:

PARTS:

Phillips #00 Screwdriver (1)

Replacement Latch (1)

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 2 of 5

Canon EOS Rebel G Back Panel Latch Replacement

Step 1 — Front Panel 

Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.

Step 2



Using your finger, peel back the textured grip so the components are separated.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 3 of 5

Canon EOS Rebel G Back Panel Latch Replacement

Step 3



Using the flat end of a spudger, loosen the connection between the front panel and the device.



Remove the front panel using your hands.

Step 4 — Back Panel Latch 

Using a 00 Phillips screw driver, unscrew the two screws located on the side of the camera. 

© iFixit — CC BY-NC-SA

www.iFixit.com

Two 4.3 mm Phillips screws

Page 4 of 5

Canon EOS Rebel G Back Panel Latch Replacement

Step 5 

Open the back panel by pushing the locking latch up.



Lift the latch cover off of the camera body.



Slide the side latch (for the back door) up and then lift straight away from the camera body.

Step 6

 Sometimes the latch will detach while pushing it up.

To reassemble your device, follow these instructions in reverse order. This document was last generated on 2017-06-19 09:59:56 PM.

© iFixit — CC BY-NC-SA

www.iFixit.com

Page 5 of 5